BOSS MPWT50 2-Way Passive Waketower Speakers User Manual
- June 6, 2024
- Boss
Table of Contents
BOSS MPWT50 2-Way Passive Waketower Speakers
Introduction
Your new MPWT50 waketower speakers are high-power, fully-waterproof 2-way systems featuring 5.25” drivers and a 1” PEI dome tweeter.
What is included?
Before you begin installation, please check that your product contains the
following contents:
- Speaker pod
- 130x14x2mm rubber mounting strip
- 120x14x1mm rubber mounting strip
- 48x30x2mm rubber mounting pad
- 2″ mounting aluminum band for 2″ and 1.875″ installation.(4) 1.75″ mounting aluminum band for 1.75″ and 1.5″ installation.(4) M6 locknut
- M6 flat washer
- M6x60mm screw
Safety considerations when installing
Please remember that these are heavy products that will be installed in a
boating environment. These vehicles can travel at high speeds and be unstable.
So please consider this and use extreme caution.
Some safety considerations include:
- Do not mount the speakers in a location where someone may either walk into or strike their head. During a turbulent ride, please make sure that you do not loosen footing and fall or hit the unit, or it may cause injury.
- Secure the wires to the speakers in multiple locations along their route to your audio source, so that there are no hanging loops of wire. Having unsecure wires in any hanging conditions can cause entanglement and injury.
- Tighten the aluminum bands with rubber inserts using care. Do not over compress the rubber inserts. After installation is complete, please recheck all bolts and tighten them further if needed before taking your boat or vessel out for an audio adventure.
- Do not install these speakers where they may block the view of the pilot and prevent safe operation of the vessel or vehicle.
Specifications
- Mid Bass Driver: 5.25” (133 mm ),Poly injection cone, Rubber surround
- Tweeter: 1” (25 mm) PEI dome tweeter
- Crossover network: Built-in
- Impedance: 4 Ohms
- Power Handling: Max 500 Watts
- Frequency Response: 140Hz – 20kHz
- Sensitivity: 92dB (1 watt/1 meter)
- Dimensions (W x H x D): 6.38” x 9” x 6.19”
- Gross Weight (in gift box): 8.05 lbs (3.65 kg)
Installation instructions
speaker wiring
Warning
- For safety, disconnect the negative terminal on the source battery prior to wiring.
- Note your amplifier impedance stability prior to wiring.
- Use only high-quality marine-grade speaker wires.
Speaker wire connection
Connect one end of speaker wires (not included) to the terminals on the speaker pod, and the other end to the audio outputs on your 12V amplifier. Make sure to observe polarity.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>