MSTHOO GEBH592AB Sport Wireless Earbuds User Guide
- June 6, 2024
- MSTHOO
Table of Contents
MSTHOO GEBH592AB Sport Wireless Earbuds User Guide
AUTO PAIRING SETUP
-
Take out both earbuds from the charging case, both earbuds will power on and enter paring mode in which the LED flashes red and blue alternately.
-
Search Bluetooth name “Fit TS1” and select it in your mobile phone.
RESET
- Turn off your device’s Bluetooth function.
- Take out both earbuds from the charging case and the earbuds will automatically enter into the pairing mode in which LED flashes blue and red alternately.
- Simultaneously keep pressing both volume up and volume down buttons of either earbud for 3 seconds.
- The paired information will be cleared and the earbuds will be off.
BUTTONS CONTROL
Q&A
Note: Remove the insulating film on the charging connectors on both earbuds before charging it.
Q1: Why doesn’t music stop when I put Fit TS1 back into the case .
Reason 1 : Earbuds might not be placed properly and not in the status of
charging.
Solution: Make sure Fit TS1 is being properly placed.
Reason 2 : The charging case is out of battery.
Solution:
- To recharge the case.
- Or manually turn off the earbuds by keeping clicking the buttons on both earbuds for 5 seconds. The earbud’s light will keep on for 1 second and then goes out. with the voice prompt “Power off”.
Q2: How to know the remaining battery of the charging case?
When you open or close the case, you will know the battery level by checking the indicator:
Q3: How to know the charging status and the full power status of the case?
Q4: How to operate if the Bluetooth disconnect or fail to reconnect?
Solution: Reset the earbuds by following the steps as previously mentioned.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>