Shenzhen Aotule Electronics Technology FH01 Wireless Phone Charger and Holder User Manual
- June 6, 2024
- Shenzhen Aotule Electronics Technology
Table of Contents
Shenzhen Aotule Electronics Technology FH01 Wireless Phone Charger and
Holder
Wireless Phone Charger & Holder
- Qi Fast Charging
- Adjustable Stand
- Infrared Sensor Lock
- Power Charging Indicator
- Foreign Object Detection (FOD)
Appearance/Button Description
How To Use
Connect the Air Vent Clamp to the device and secure them by screwing the Fixing Nut.
- Turn clockwise to lock
- Turn counterclockwise to unlock.
When putting the phone closer to the wireless charger, the electronic arm will open automatically.
Notice: Adjust the stand to get the best alignment.
Press the unlocking key on either side of the device to open the arms
Pull down to lock and secure the connection after the sucker sucks onto the glass.
Specification
Input(max): 5V/2A;9V/2A;12V /1.8A
Output: 5W 5V/1A ;7.5W 7.5V/1A 10W 9V/1.12A ;15W 9V/1.67A
Troubleshooting
-
The Charging Indicator flashes red light and the wireless charging can not go on.
Reason: The Foreign Object Detection (FOD) feature is working. It means: -
The receiving coil of the phone is not well aligned with the charger’ transmitting coil. Please adjust the stand to get the best alignment. The phone’s receiving coil is usually located in the back center and the transmitting coil of the charger is marked as a circle on the surface. A good alignment can ensure the charging efficiency.
-
Metal object other than phone is put on the surface of the charging panel
-
Phones that doesn’t support wireless charging is put on the charging panel
-
The temperature of my phone goes high during wireless charging.
Reason: It’s pretty normal that the phone’s temperature goes high when running navigation app or playing video on your phone during wireless charging. If the temperature goes extremely high, please stop the charging and charge it again after the phone cools down, or install the phone holder over the vehicle’s air vent.
Write to us if you need further help ([email protected])
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and
20 cm above the top surface of the device must be respected.