Danmeizi shenzhen fushiyouxiangongsi DM-L01BL 3 in 1 Charging Station Instruction Manual
- June 6, 2024
- Danmeizishenzhenfushiyouxiangongsi
Table of Contents
Danmeizi Shenzhen fushiyouxiangongsi DM-L01BL 3 in 1 Charging Station
- Highest internal frequency: 350kHz 0
- Input DC 5V2.1A-5V3A
- @ Output: DC 5V2A
PART LIST
instruction manual
-
Flip up the folding phone supporting part.
-
@ Press the red area to make the phone “lightning” port stand upright.
Find a suitable and stable charging angle for your phone, then align the phone and insert it. -
E) Stand the watch charger upright to charge.
Put your watch on the watch charger holder. -
Press the red area to make the AirPods “lightning” port stand upright.
Put your Airpods on the AirPods charger holder.
warm tips
-
The phone can be placed horizontally on the stand.
-
The maximum upright angle is 90 degrees. Force may break the stand.
-
Reach us by your Amazon order detail page (select “order” “sold by” or “contact seller”) for warranty about it.
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
the device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>