MOUSER ELECTRONICS ESP32-C3-DevKitM-1 Development Board User Guide
- June 6, 2024
- MOUSER ELECTRONICS
Table of Contents
MOUSER ELECTRONICS ESP32-C3-DevKitM-1 Development Board User Guide
ESP32-C3-DevKitM-1
This user guide will help you get started with ESP32-C3-DevKitM-1 and will also provide more in-depth information.
ESP32-C3-DevKitM-1 is an entry-level development board based on ESP32-C3-MINI-1, a module named for its small size. This board integrates complete Wi-Fi and Bluetooth LE functions.
Most of the I/O pins on the ESP32-C3-MINI-1 module are broken out to the pin headers on both sides of this board for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-C3-DevKitM-1 on a breadboard.
ESP32-C3-DevKitM-1
Getting Started
This section provides a brief introduction of ESP32-C3-DevKitM-1, instructions on how to do the initial hardware setup and how to flash firmware onto it.
Description of Components
ESP32-C3-DevKitM-1 – front
Start Application Development
Before powering up your ESP32-C3-DevKitM-1, please make sure that it is in good condition with no obvious signs of damage.
Required Hardware
- ESP32-C3-DevKitM-1
- USB 2.0 cable (Standard-A to Micro-B)
- Computer running Windows, Linux, or macOS
Software Setup
Please proceed to Get Started, where Section Installation Step by Step will quickly help you set up the development environment and then flash an application example onto your ESP32-C3-DevKitM-1.
Hardware Reference
Block Diagram
The block diagram below shows the components of ESP32-C3-DevKitM-1 and their interconnections.
ESP32-C3-DevKitM-1 Block Diagram
Power Supply Options
There are three mutually exclusive ways to provide power to the board:
- Micro USB port, default power supply
- 5V and GND header pins
- 3V3 and GND header pins
It is recommended to use the first option: micro USB port.
Header Block
The two tables below provide the Name and Function of I/O header pins on both sides of the board, as shown in ESP32-C3-DevKitM-1 – front.
J1
J3
P: Power supply; I: Input; O: Output; T: High impedance.
Pin Layout
ESP32-C3-DevKitM-1 Pin Layout