pagee PG1 Mobile Sticker Printer Instruction Manual
- June 6, 2024
- pagee
Table of Contents
pagee PG1 Mobile Sticker Printer Instruction Manual
Pagee Components
Pagee Introduction
Power Button LED status
Press power button for 3 second to tum the power on/off.
- LED white : Ready to print, Fully charged
- Blinking with 4 lights: Recharging
- Blinking slowly: Need Battery charge
- Blinking fast: Need paper, cover not dosed, error
Charging Port: Battery Recharge
- Connect to smartphone power bank or PC to recharge with cable.
- Please Charge fully before using Pagee.
Power Bank Port : Smartphone Recharge
- While Pagee is power on, it can recharge smartphone. bluetooth earphone, speaker etc. (High currency such as Tablet my not work)
How to use
Pagee App
How to Connect?
How to connect to Pagee?
After activate smartphone’s bluetooth, please proceed.
- While power on, double dick the Pagee’ s power button It will print OR code.
- In the Pagee app, scan the OR code to connect with Pagee.
Cartridge Setting
Pagee Caution
·FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
inducing interference that may cause undesired operation.
– FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance <DU Id void the user’s authority to operate this equipment This
transmitter must not be co-located or operating in conjugation with any other
antenna or transmitter.
– FCC interference Statement
This device has been tested and found to comply with limits for a Oases 8
digital device. purS1.1ant to part 15 the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
Pagee Caution
Cartridge Caution
This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not in a particular installation. fifths device does reuse harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to correct the interference by one of the following measures:
□ Reorient or relocate the device.
□ Increase the separation between the device and the receiver
□ Connect the device into an outlet on a circuit different from which the
receiver is connected.
□ Consult the manufacturer for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.