Shenzhen Qichen Lighting XDD-01 LED Ceiling Lamp Instruction Manual
- June 6, 2024
- Shenzhen Qichen Lighting
Table of Contents
XDD-01 LED Ceiling Lamp
LED Ceiling Light
|
Product Parameters
◆ Size: φ13.8 X 1.65Inch
◆ Input Voltage: AC 100V-277V 50/60HZ
◆ Working Temperature: -20℃-45℃
◆ Beam Angle:160°
If any problem when you install, send us email to:[email protected]
Installation Instructions
a .Use tapping screws and Anchors for solid ceiling
b .Use flat head screws for junction box
|
Lamp is made of insulating plastic ,s
|
Rotate the lamp clockwise and installfinish installation !
Operating Guidance
1.Search“TuYa”at App store and install the APP (Or Scan the following QR code by your phone)
2.Log in your TuYa App (Please sign up when use at first time)
3.Click “Add device“.
Select Device”Lighting＞Light Source＞Light Source(Wi-Fi)”
|
4.Firstly,ensure it in state of light off, cycle lights on/off 2 times, then turn on the light, it will start blinking. (When you turn on the light, if it’s blinking fast, skip the reset step)
5.Confirm the lamp is blinking and connect to the 2.4g Wi-Fi
6.Click “device” into the control panel.
---|---
|
How to control the lightphones at the same time?
|
2
3
|
4
FCC Warning This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: -Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver. ·Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. ·Consult the dealer or an experienced radio/TV
technician for help. Radiation Exposure Statement To comply with FCC RF
exposure compliance requirements, this grant is applicable to only mobile
configurations. The antennas used for this transmitter must be installed to
provide a separation distance of at least 20cm from all persons and must not
be co-located or operating in conjunction with any other antenna or
transmitter.