Wiseasy N5 Smart 5.0 Inch Touch Screen Handheld Pos Terminal Card Swipe Machine Pos System User Guide
- June 6, 2024
- Wiseasy
Table of Contents
N5 Smart 5.0 Inch Touch Screen Handheld Pos Terminal Card Swipe Machine
Pos System
requirement. The FCC has granted an Equipment Authorization for this device
with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this device is on file with the FCC
and can be found under the Display Grant section of
http://www.fcc.gov/oet/fccid after searching on FCC ID: 2AXOJ- WISENET5. For
body worn operation, this device has been tested and meets the FCC RF exposure
guidelines for use with an accessory that contains no metal and the positions
the device a minimum of 10 mm from the body . Use of other enhancements may
not ensure compliance with FCC RF exposure guidelines. For handheld operating
condition, SAR meets with FCC limit 4.0W/kg.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received,
including interference that may cause undesired operation. Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver. –Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help.
LTE 2, 4, 5, 12, 17, WCDMA 2, 5 GSM 2, 5
RF Exposure Information (FCC SAR) : This device meets the government’s
requirements for exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. The exposure standard for wireless devices employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6 W/kg. *Tests for SAR are conducted using standard operating
positions accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the
device while operating can be well below the maximum value. This is because
the device is designed to operate at multiple power levels so as to use only
the poser required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output. The highest SAR
value for the device as reported to the FCC when worn on the body, as
described in this user
guide, is 0.36W/kg (Body-worn measurements differ
among devices, depending upon available enhancements and FCC requirements.)
While there may be differences between the SAR levels of various devices and
at various positions, they all meet the government
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>