HL Audio WS-858 Wireless Microphone Instructions
- June 6, 2024
- HL Audio
Table of Contents
WS-858 Wireless Microphone
WIRELESS MICROPHONE Instructions
v I Butt ‘ peml n
Hold ON OFF P,ess Mode swi1chlog
2
P,es” the p,evioes soag “”‘”MP3 ccrle Under see morle pmss ii lo eoate
selfiefunct1on (ocly fc, iOS system mohi e phcce) 3”’v'” Prnss, the prnvio”s
soog “”d”MP3 mm Uow selfie mcde, p,esst to enable selfie function
olyfo, Aod,oirl system mobile ph ce)
‘4 II
P,esP ay/Pa”se.Unde,FM slate, h Id it forautorralic search
5QMIC/Rlay
Pess: Mike ON OFF
+ Hold, Reayf”oclioo vnde, TF ca,d play mcce
‘loaease vol”me
7 · – ‘Decrease volume
ll WireleKar.a ke
1 . S”pply powm· Ho rl
b”lloo lo startlhe pm·”ot
2. Wire es conner.lion: enab e the wireless orbile phooe. dick toroooect
` saccessf”I coooeclioo if p,ooptone is reduced.
3. AdJesl soaod ad1vs< the s und volume f rrike and the reverberalion to su
table level
4. StartKa,aoka
Ill Raoo,ding with m bilaph
Cooo,ct tha ,amd og “”” iosM Iha MICRO plo, oftha ,eco,diog “”” mto thaMICR
interface ofKara ka T”””‘” ,oo a 3.5mm iotartac, ioto the ea,ph oajackof lMmob,la phrna
2. Opao t eKa,aokeaohwa,emthe m bl e re sue as: USG K”g uMusic or therreco
‘”°” APP, setect yoo, fa. rable sog,
the scccacco<dlog to the atx,,e meotioo”‘ siogiog methcd
3est aod sa.elhe 0000;0ernte accdmcto lhe lOst,cclns ofKaraoke software
IV.Selfiefunction 1 Press theI)”b””‘” to switch frorr wlceless o ccie lo seiie
mode,
2. Enable wireless in the m hile phnoe swc, ‘shctte,” dick conoeolioo 3. c,so
th, pho <>g,aph interta ofthe mobi , p<coe pss lhe ·o ··bsttootolake phctos
°’ Note:4.2.2 ohighec.ecsioa rm Aod,rnd system, 6.0 h ghe, ve,sioo foOS system
il d eso t s”ponothe,e,sioos lempo,a”ly. II d esn t sppothe mobile ph oe which
has the mdepeadeol aod solid photog,aph ‘””‘”
Toch,lo,I Pmmete
· o,,,,, p W” 5W
· F..q,oocy “‘”” 100HZ-10KHZ
‘ · M;ixs undPressurelevel:>1 SOB 1KHZ TDH<1%
· ReverberahonMOOe: sound eect reveberation
, Pcwecsc,plyill'” 18650 L, balle,y
· Batte,yCapacity’800mAh , Chagloo PowDCW
FCC Caution This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: -Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. -Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>