antaira RS232 Serial to USB Adapter Cable Installation Guide
- June 6, 2024
- antaira
Table of Contents
RS232 Serial to USB Adapter Cable
Installation Guide
Introduction
Thank you for purchasing this RS232 Serial to USB2.0 Adapter Cable (the “Adapter Cable”). It is an intelligent expansion cable that connects to a PC or server via the Universal Serial Bus (USB), providing high-speed serial connectivity. The serial port is fully compatible with the RS232 serial standard by the bundled virtual COM port drivers. With its compact size and mounting options, it is an ideal and instant solution for most critical applications.
Connector Layout
Features:
- Provides 1 RS232 Serial Ports over USB Port
- Provides 1 DSUB-9 Male Connector
- Supports USB2.0 Full Speed (12Mbps) Data Rate
- Baud Rate from 300 bps to 921.6Kbps
- Supports 7,8 Data Bits
- Odd, Even, Mark, Space, or None parity mode
- Supports 1, or 2 Stop Bits
- Supports USB Bus Power
- Supports TXD and RDX Activity LED Indicators
- Supports Win98, Me, XP, CE, Win2000, 2003, Vista and Windows 7, Linux and Mac OS
Plugging the Adapter Cable
- Plug the USB Type-A end of the Adapter Cable into the USB host port of your PC or into an available USB port on a USB hub.
- Connect the RS232 Serial Device to the DB9 male connector of the Adapter Cable.
- Proceed with the next section “Installing Drivers” to install the virtual COM port drivers for your Operating System.
Installing Drivers
The Adapter Cable can be hot-plugged to the USB port of your computer due to the specifications of USB. It supports the following operating systems. The drivers are shipped in the following folder on the supplied driver CD.
Driver Locations on the CD
These instructions are for installing the drivers from the CD supplied with
the product. If you are installing drivers for Win98, ME, 2000 or XP, when
prompted for the location of the drivers, specify your CD-ROM drive and the
locations according to the following table:
Installing Drivers for (32-bit and 64-bit) Win7, XP, Vista, 2008, 2003, and 2000:
- Insert the Driver CD supplied with the Adapter Cable.
- Run (or double click) the Installer Program (e.g. CDM20600.exe ) in the following folder of the driver CD: \USB_to_IO\FTDI\ (32_64bit)Win7_XP_Vista_2008_2008R2_2003_2000
- Follows the instructions of the installer program to complete the setup procedures.
- Plugging the Adapter Cable will hook the drivers into the Windows kernel automatically.
Male DB9 Pin Assignments and Cable Wiring
| 9 Pins | Signal |
|---|---|
| 1 | DCD |
| 2 | RXD |
| 3 | TXD |
| 4 | DTR |
| 5 | GND |
| 6 | DSR |
| 7 | RTS |
| 8 | CTS |
| 9 | RI |
DB9(Male) to DB9(Male) Wiring
Environmental Specifications
| Power requirements: | 5V DC, 135mA (max) |
|---|---|
| Operating temperature: | 0 to 558C (32 to 1318F) |
| Operating humidity: | 5 to 95% RH |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>