Senson Electronics Technology T7 True Wireless Earbuds User Manual

Uesr Manual
T7
Ture Wireless Earbuds

What’s in the box

PRODUCT OVERVIEW

PRODUCT OVERVIEW

INSTRUCTION

Play / Pause / Answer Call / End Call / Reject Call /SIRI /Next song/Previous song/Volume up/Volume down

1. How to pair and connect when first use?
   Step 1:Take out the earbuds from the charging case,it will power on and pair. Then can be searched on your device.
   Step 2: Activate the Bluetooth on your device. Find and connect ‘T7’.

2. Don’t have a master/slave relationship
   1. In binaural mode, only need to put any earphones back into the charging case and the other earphone will continue to work.
   2. Under the single ear model, whichever earphone you use, take out another earphone, they will automatically connect and convert to binaural mode.

TROUBLESHOOTING

Issue：

1. One earbud stopped working.

2. One earbud can’t pair.

3. Fail to connect ‘T7’
   Solution:
   Step 1: Put two earbuds into the charging case and close it.
   Step 2: Forget the device from your Bluetooth on your device.
   Step 3: Take out the earbuds from the charging case, Activate the Bluetooth on your device. Find and connect ‘T7 ‘
   .Issue:

4. One the earbud keeps flashing blue light at fast speed.

5. Both of the two earbuds indicators alternately flash red and blue.
   Solution:
   Please reset them.
   Issue:

6. Two earbuds show blue light with slow speed.

Solution:
Check whether earbuds connect with another device automatically. You need to disconnect them with another device.
If you need to reset, please follow the below steps,
Step 1: Turn off both of the earbuds first. (Touch the touch panel and hold for 5s, you will hear the ‘power off’ from two earbuds.)
Step 2: Forget the device from your Bluetooth on your phone.
Step 3: You can reset them now. (Touch the touch panel and hold on 10 seconds for both earbuds until hearing three short beeps from two earbuds. Please don’t release the
touch panel even hearing ‘power on. )
Step 4: Activate the Bluetooth on your device. Find and connect ‘T7’.

PRODUCT PARAMETERS

• Bluetooth Ver.:NoV5.0
• Transmission frequency:2.4G~2.48G
• Wireless Range:≥10m
• BT Music Play Time:5-6H
• Talk time:≥6H
• The battery in headphone:40mAh x 2
• Battery in case:450mah
• Charging time:1-1.5H
• Earbuds weight:4g*2
• Charging case weight:21g
• Speaker:13mm

FCC

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AYVK-GOME00T7

ATTENTION

1. Please fully charged the device before using it, if long time not used.
2. The earbuds will automatically turn on and paring when opening the charging case.
3. Our wireless earbuds will connect with the latest device automatically after use.
4. Do not put the device in a high-temperature environment or into a fire, as not to damage the battery.
5. 3o avoid damaging the battery, do not put the products into a high-temperature environment or fire.
6. Deal with the waste batteries according to national regulations.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>