Dr Morepen BG-03 Blood Glucose Test Strips User Guide
- June 6, 2024
- Dr Morepen
Table of Contents
QUICK REFERENCE GUIDE
BATTERY INSTALLATION
Open the battery compartment given at the back of the meter & place the battery with ‘+’ symbol facing up.
SETTING UP LANCING DEVICE
|
---|---
Unscrew and open the cap of the lancing device.| Insert a new lancet firmly up
to the bottom of the lancet carrier.
|
Twist & remove the cap of the lancet to expose the needle.(Keep the cap
aside,do not throw it).| Close the lancing device by putting back its cap.
|
Adjust the depth required for pricking as per the thickness of the skin.| Hold
the tip of the device firmly in one hand & pull out the sliding barrel with
the other hand,to load the device.
MONITORING BLOOD GLUCOSE
Insert the strip into the meter’s strip slot with the white arrow pointing
towards the meter and facing upwards.
|
When the flashing blood symbol ( ) appears (in 3 seconds), the meter is ready
for you to apply blood to the blood glucose test strips.| Use your lancing
device to obtain a blood drop. Hold it against the side of the finger. Press
the release button to prick & obtain a blood sample.
Touch the blood drop to the sample channel at the end of the strip. The blood
is drawn into the test strip automatically. Continue to touch the blood drop
to the end of the test strip until you hear the beeper.
|
After the beeper sound,the meterwill count down from 5to 1, and your blood
test result will be displayed.| Remove the used lancet from the lancing
device. Push its needle into the lancet cap that was kept aside,so that it
does not harm anyone, and then discard the lancet.
Before using this product, carefully read the manual. I Do not take any medical decision without consulting a doctor. I Always discuss your result with a Registered Medical Practitioner.
DC-BG-702Ner. No.-01/lss. Dt. 01-Aug-2019/Eff. Dt. 01 -Aug-2019
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>