Zhongshan Rixiao Photoelectric Technology RX3030-12W LED Flat Lamp Instruction Manual
- June 6, 2024
- Zhongshan Rixiao Photoelectric Technology
Table of Contents
LED flat lamp manual
To users: Thank you for purchasing rixiao photoelectric products. Please read the manual carefully before installation and use
installation instructions:
Before installation, be sure to cut off the power supply to protect the safety of operators.
Ceiling frame: 306.5×306.5x17mm
Lamp size: 300 x 300 x 14mm
The minimum length oft-shaped protruding supporting lamps is 3.0mm
The minimum thickness of t-shaped protruding supporting lamps is 1.0mm
Installation steps
- Remove the corresponding gusset plate from the ceiling where the lamp is installed:
- Connect the power cord between the lamp body and the driver:
- Insert the white supply wire (neutral) into quick wire connector with the preassembled white focture wire. Insert the black supply wire (hof) into quick wire connector with the preassembled black fracture wire. Insert supply ground wire into quick wire connector with the preassembled ground wire. Make sure all connections are secure, tuck all wires inside the junction box Push junction box into the ceiling opening, and fx with screw. Close the cover of the connection box
- Buckle the lamp body into the keel groove where the buckle plate is removed
The keel groove is fixed with the edge Mosaic of the lamp.
Safety precautions
- The power supply should not exceed the specified range (input voltage range: 120V-. frequency: 60 Hz);
- Do not install the lamp on the open air, inclined place, or unsound objects
- Do not use with dimmer and electronic switch
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- When the lamp is abnormal, please cut off the power supply quickly and contact the sales shop
FCC Statement:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try correct the interference by one or more of the
following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>