Chaos Audio CHAOS-Q1 Guitar Pedal User Guide
- June 6, 2024
- Chaos Audio
Table of Contents
CHAOS-Q1 Guitar Pedal
User Guide
CONTENTS
AUTO PAIRING
CHARGING
MUSIC
CALL
WARNING
- DO NOT use alcohol, paint thinners detergent shampoo, or other solvents for cleaning purposes.
- DO NOT intentionally immerse the earphones under water for tong time.
- DO NOT wash the earphones in washing machine.
- DO NOT expose the product to extremely high or low temperatures
- DO NOT Leave the product near candles, cooking bumers and open flames.
- DO NOT disassemble the product in any way to avoid electric shock. Only charge the battery in accordance to the instructions provided by the company.
- DO NOT wash the charging box.
CAUTION
RISK OF EXPLOSION INCREASES IF BATTERY IS REPLACED BY AN INCORRECT TYPE
DISPOSE USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
INSTRUCTIONS
DO NOT DISCARD THE USED BATTERIES ALONG WITH HOUSEHOLD WASTE DISPOSAL OF
BATTERY SHOULD COMPLY WITH LOCAL ENVIRONMENTAL REGULATIONS.
Product Specification:
- Bluetooth chip: QCC3020 v5.0 Dual ear direct connection, regardless of master-slave, master-slave switching function Support apt-X audio decoding (HD decoding)
- Receiving distance: within 10m
- Working frequency: 2.402 GHz ~ 2.480 GHz
- Transmission power: class2, max4dbm
- Audio decoding mode: apt-X, AAC, SBC
- Charging input voltage: DC5 ± 0.25V
- Battery Specification: 3.7V 50mah (headset); 400mah (charging box)
- Working voltage: 3.7V (3.3-4.2v)
- Charging time: 1.2h
- Sensitivity of microphone: – 38 ± 2dB
- Low voltage prompt: 3.3V
- Speaker specification: 16 Ω / 6mm
- Frequency response range: 20 ~ 20KHz
- Sensitivity: 99 ± 3dB
- Continuous call: ≥ 4H
- Continuous music playing: ≥ 4H
- Standby time: ≥ 100h
WARRANTY CARD
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.