bigston C500 LCD Display USB Aansluiting Controlle User Manual
- June 6, 2024
- bigston
Table of Contents
BIGSTONE C500
Turning on the display
Press the “On/off” button (A) left of the display to turn the electric circuit on. The display is turned on and a menu appears.
A = On/off button and lights
B = Menu display
C = Motor support up
D = Motor support down
Switching bicycle lights on and off
****Press the “On/off” button (A) once to turn on the lights. A symbol will appear on the display. Press button (A) again to turn it off.
Thumb lever
****By pushing the lever (A) forward when stationary, the walk assist will be activated (which gives support up to 6 km/h). Walk assist will be activated when the (-) button is pressed for a few seconds.
Attention: Walk assist does not work when support mode is set to ‘0’. Using the lever while pedaling, the support will go to its maximum speed of 25 km/h.
Switching between the 9 levels of electric
support
**The electric support has 9 positions. The current support setting is shown at the bottom left of the display. You can switch between these settings by briefly pressing the “+” (C) or “-“ (D)** button.
USB – port
**Below the display is a USB port (A)** where you can charge, for example, your smartphone or navigation device while cycling. You must activate the port by pressing the “set” and “+” buttons for a few seconds.
Reset Trip mode
**Press the “SET” button (B) for a few seconds, maintenance menu will appear. Press the “- “button (D) once to reset trip mode. Press the “SET” button (B)** again to exit the menu.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>