Park Life Bil-ParkOne2 Parking Disc Instruction Manual
- June 6, 2024
- Park Life
Table of Contents
Park Life Bil-ParkOne2 Parking Disc
Let’s get started with your Park Life
How to activate your Park Life :
With the back of the parking disk facing you, place tree fingers on top of the large cen-tered round button and turn it clockwise until the two small dots meet and the Park Life logo is parallel to the inner display. Within 15 seconds ”hours” flashes in the dis-play and the unit is ready to be set. (To deactivate; turn the large button counter clock-wise until the display shows no numbers. Wait min. 2 minutes before reactivation).
How to set the digital clock:
The Park Life parking disc clock sets automatically even when the clocks go back or forward (daylight saving time). However, if necessary, this function can be deactivated manually
- If A: How to activate your Park Life is followed, please skip step 1., otherwise continue as follows:
- To activate the setting function, press and hold down the lower part of the large button ❶ (aprox. 10 sec) until ”hours” starts to flash.
- When ”hours” flashes, press repeatedly on the upper part of the button ❷ until the clock is set at the correct hour.
- Press ❶ once until ”minutes” starts to flash. Set minutes by pressing ❷.
- Set year, month and date as described above (in this order).
When the above settings is completed, none of the digits in the display should flash. NB: Note, however, that the two dots (:) between the hours and minutes flash all the time. If one of the digits flashes, press ❶ repeatedly until no digits are flashing. If you discover that you have set Park Life incorrectly, you can always start again. Press and hold down ❶ (aprox. 10 sec) until the ”hours” digit flashes. We recommend that you check the parking disc settings regularly, especially at daylight saving time.
Activating/deactivating daylight saving time:
By default, the digital clock is set to change automatically to and from daylight saving time. If, however, you are in a country, which does not use daylight saving time, you can deactivate this function as follows:
- To activate the setting function, press ❶ and ❷ until ”hours” and ”minutes”show ”oN:Su” in the display.
- Carefully release ❶.
- Press and hold down ❷ until you read ”oF:Su” in the display.
- The display reverts automatically to normal function.
Your Park Life is now ready for fitting on the inside of your car windscreen.
Don’t forget: you are permitted to have only one parking disc in the vehicle
and that the driver is always responsible for setting the clock correctly.
Needit ApS and Needit Denmark ApS do not refund parking fines.
How to fit Park Life
Find a suitable spot inside the car at the lower, right-hand corner of the windscreen (this is a legal requirement) where all four adhesive pads are in contact with the glass. Make sure that you can access all the buttons on the back of the parking disc.
- Clean the area on the inside of the windscreen where you will fix your parking disc, with a damp cloth and a little household detergent. Dry the windscreen and then use the enclosed cleaning cloth to thoroughly degrease the area. (Use the enclosed cleaning cloth – no other cleaning agents).
- Make sure that the windscreen is at least +15°C. The adhesive pads are not as effective at lower temperatures. The glass can be heated using the car heater or (carefully) with a hair dryer.
- Remove the protective foil from the four adhesive pads and press the parking disc hard against the glass for about 30 seconds. Do not press on the middle of the back of the disc. Check from the outside that all four adhesive pads have adhered to the glass.
- You have now fitted your Park Life parking disc and are ready to drive.NOTE!
- Park Life parking disc should not be left unattached in the car. Your parking disc will not function correctly unless it is securely attached to the windscreen.
How does Park Life work?
When you park your car, Park Life sets automatically to the next quarter of an
hour after your time of arrival (e.g. if you arrive at 10:07, Park Life sets
itself to 10:15).
The driver of the vehicle is responsible for ensuring that the disc is set
correctly. Need it ApS and Need it Denmark do not refund parking fines and
Need it cannot accept responsibility for defective fitting.
How to set arrival time manually
Your Park Life can also be set manually. This function is a legal requirement
in Denmark. Executive Order no. 150 of 24/02/2016 (Article 3(3)) states: ”If,
while the vehicle is parked, a period begins in which unlimited parking is
permitted, the parking disc must be set to display the time for the beginning
of the parking period or (no later than the end of this period) to display the
time from which a new limited parking period will begin.” If you need to set
your Park Life parking disc manually, press ❷ and the clock will run on at
15-minute intervals. NB: This function is only accessible when Park Life
parking disc is in parking mode. Batteries Park Life has a product lifetime
battery, which means you will not need to change the battery. Under normal
circumstances, the battery in any Park Life will work for at least 10 years.
Service and guarantee
If you have questions about your new Park Life, you will find many answers on
our website at www.needit.dk If you have questions,
you are also welcome to send an
e-mail to kundeservice@needit.dk Needit ApS and Needit Denmark ApS provide a
product guarantee in accordance with the Danish Sale of Goods Act. If, during
the guar-antee period, you find an error or defect in your Park Life parking
disc, you can return it to the retailer, from whom you bought the disc. The
disc will be repaired or replaced. If you have a complaint, please bring a
copy of your receipt (as proof of purchase).
Approvals and certificates
Park Life is approved by the Danish Transport Authority in accordance with Executive Order no. 150 of 24/02/2016 on parking discs and approval code FS29 is imprinted on the front.
CE labelling
By means of the CE label on the parking disc, Needit ApS declares that our
product meets the general safety requirements contained in the CE labelling
directives. By means of the CE label, the manufacturer guarantees that the
product is manufactured in accordance with joint European safety, health and
environmental requirements. Needit ApS declares that this parking disc meets
(CE) EN 55022 (Radio Disturbance Characteristics) and (CE) EN 55024 (Standards
for Commercial Electronic Products) requirements.
WEEE
Electrical and electronic components (EEE) and materials can be harmful to the
health and environment, and must be correctly disposed of.
Park Life is not to be disposed of in the general trash, but has to be
disposed of indi-vidually. The battery can be returned at any retailer selling
batteries, and the actual Park Life can be disposed of at your local recycling
station or at the retailer.
Specifications and rights
Size (cm) : 10 x 10 x 1.5
Battery specification : Lithium cell that does not require replacement
within the prod-uct lifespan
Battery lifetime : Min. 10 years
Clock precision (avg.): ± 2 min./2 years
Response time – parking : About 20 seconds
Response time – exit parking mode : About 20 seconds
Park Life patent applied for.
All rights to the Park Life product are the property of:
Needit ApS • Hammerholmen 18 • DK-2650 Hvidovre
Telephone: +45 70 221 535
E-mail: kundeservice@needit.dk
Web: www.needit.dk
Needit reserve the right to make changes to the content of these instructions
without prior warning.
NOTE: The driver of the vehicle is responsible for ensuring that the disc
is set correctly. Needit ApS and Needit Denmark do not refund parking fines
and Needit cannot accept responsibility for defective fitting nor setting.
References
- NEEDIT elektroniske parkeringsskiver
- Park Life - P-skive du aldrig skal skifte batteri på! Park Life - P-skive du aldrig skal skifte batteri på!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>