LeMeng LED Low-Voltage Recessed Ceiling Light User Guide
- June 6, 2024
- LeMeng
Table of Contents
LED Low-Voltage Recessed Ceiling Light
User Guide
LED Low-voltage Recessed Ceiling Light User Guide
**** Precautions:
- Before the installation, please cut the power off!
- Please strictly follow the instructions. If improperly installed, the product may not work properly, the power supply may fail, the item part may fall off and etc.
- In case of a lamp falls off, is damaged, or gets electric shock and other major accidents happened, please do not arbitrarily modify the lamp or adjust the parts.
- To avoid unnecessary trouble after the installation, please test the item on a power upstate before installation.
- To ensure correct installation, it is important to commission the electrician to perform the operations. Non-professional operation is dangerous.
- The remote control requires 2 AAA batteries to supply power, and the battery is not included when shipped.
Parameter
LED Low-voltage Recessed Ceiling Light
| LED Amount | 30 LED |
|---|---|
| Power | 3W/PCS |
| Working Voltage | 12V |
| Luminous | 240LM |
| CR1 | 80 |
| Color Temperature | 2700K-6000K |
| Dimmable | Yes |
| Wire length | 1m |
| Hole size | 60 – 65mm |
| Materiel | Aluminum + PC |
Components and structure
Installation Steps
Step 1:Cut off the power.
Step 2: Drawing line and cutting hole in the installation site.
Step 3: Connect the fixture cable to the power cable.
Step 4: Push the lamps into the hole, the lamp will fit into the ceiling.
Step 5: When the installation is completed, open the switch and the lamps will
work properly.
After-sale service
Thank you again for purchasing our product. If you have any questions about
the product, please feel free to contact our customer service team. We will
reply to you within 24 hours, and promise to offer a 100% satisfied solution.
Finally, we wish you a happy life!
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment