FURRION FSBNN30MSS-BL Aurora Bluetooth Soundbar User Guide
- June 6, 2024
- FURRION
Table of Contents
FURRION FSBNN30MSS-BL Aurora Bluetooth Soundbar
BASIC OPERATION
Soundbar Buttons
Remote control Button|
Function
---|---
| Power on/off.
| Short press to switch the source mode to Bluetooth; Press and hold it for
3s to unpair and launch pairing again. (BT Name: Furrion SB 2.1)
| Select the audio source (AUX, RCA, COAX, BT).
| Mute or un-mute the audio output.
| Skip to the previous track in BT mode.
| Start or pause playback in BT mode.
| Skip to the next track in BT mode.
/| Adjust volume.
|
Select the different EQ mode.
| Remote control Button|
Function
---|---
| Power on/off.
| Short press to switch the source mode to Bluetooth; Press and hold it for
3s to unpair and launch pairing again. (BT Name: Furrion SB 2.1)
| Select the audio source (AUX, RCA, COAX, BT).
| Mute or un-mute the audio output.
| Skip to the previous track in BT mode.
| Start or pause playback in BT mode.
| Skip to the next track in BT mode.
/| Adjust volume.
|
Select the different EQ mode.
Tip : See the complete user manual online for detailed functional explanation.
Mount on wall
CONNECT POWER
INSTALL REMOTE CONTROL BATTERY
WHAT’S IN THE BOX
CONNECT
Open the protective cover on the back by removing the screws then connect the cables.
Note : All external devices and cables shown in the diagram are for reference only and not included in the package.
Connect Soundbar with TV
Connect Soundbar with other devices
After the connections are completed, close the protective cover and tighten the screws for the best weatherproof effect.
INSTALL
IMPORTANT : Before final installation, check by powering the Soundbar on to make sure the unit operates properly.
Install Soundbar to the compatible Furrion Aurora™ TV
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>