nuvoh2O MANOR TRIO Water Softener Filtration System Installation Guide

: June 7, 2024
: NuvoH2O

Table of Contents

nuvoh2O MANOR TRIO Water Softener Filtration System
What To Expect From Your Manor Trio System
Simple & Effective
Package Contents
System Maintenance
Before Installation
Installation Instructions
NuvoH2O Filter and Cartridge Replacement
Money-Back Guarantee
Read User Manual Online (PDF format)
Download This Manual (PDF format)

nuvoh2O MANOR TRIO Water Softener Filtration System

Welcome to the NuvoH2O Family of Whole-Home Water Softener Systems.

Congratulations on your purchase of the NuvoH2O Manor Trio System. Instead of using salt or potassium to soften your home’s water, NuvoH2O uses CitraCharge, a proprietary, all-natural, citrus formulation to soften and condition your home’s water. Initially developed for the food service industry in the early 1980s, this remarkable technology has been solving complex water problems for many of the nation’s largest businesses.
You are about to enjoy healthier, better tasting, and softer water that both prevents and removes hard water buildup that clogs and corrodes
water heaters, appliances, and plumbing fixtures–each critical to your home and expensive to replace.
Once installed, your home’s water will be transformed into healthier water. Better yet, soon you’ll see any pre-existing, hard water scale begin to disappear.

What To Expect From Your Manor Trio System

The Manor Trio System softens and improves your water’s taste. It prevents hard water buildup by binding naturally occurring minerals without removing them. Naturally mineralized water is healthy and is not affected by the NuvoH2O softening process.
NuvoH2O-softened water requires less soap in your dishwasher and less detergent when doing laundry. You can decrease up to half the amount for both. Avoid using pre-soaks or rinse-aids since too much of either can cause a fine white film or spots to form on dishes. This spotting can also be aggravated by some of the non-phosphate detergents found in many states.
Pared with your softener cartridge, the Manor Trio System is supplemented by your choice of two of our four cartridges. Each has its own set of unique features designed to meet your personal needs.
The following describes each of the four cartridges and their applications:
The Taste Filter removes up to 95% of chlorine, and inorganic chemicals–providing a notable improvement in your water’s taste and smell.
The Iron Filter is designed to provide an easy and effective method of reducing iron from water, which greatly improves the taste. It reduces the possibility of damage to pipes and water heaters, eliminates the orange and brown stains often found in sinks, toilets, and tubs, and reduces up to 3 ppm of dissolved iron. The cartridge adds no harmful chemicals to the water, making it completely safe for drinking water applications.
The Sediment Filter is intended to be a first line of defence to your Manor Trio System. When used, the sediment filter will catch and effectively remove large particles such as sand, rust, gravel, debris and other suspended particles.
The Chloramine Filter is our finest filter option, equipped with a 1-micron filter. This option exceeds the filtering capabilities of our Carbon Taste filter option, removing chloramine in addition to 95% of chlorine, and inorganic chemicals and thus dramatically improving your home’s water taste and smell.
The NuvoH2O line of Manor Trio Systems was created foremost with optimum efficacy and simple design; offering both superior, eco-friendly water softening with solutions for other common water issues. Systems do not require drains, electricity, or calibration, and require little maintenance. Since the softening formula is citric-acid based, an FDA-approved ingredient, it is safe for all household uses, including drinking, bathing, and watering plants.

Simple & Effective

Your new system mounts directly to your home’s main internal water line and does not require a soft-water loop. We strongly encourage hiring a professional plumber to install your system.
However, if you are experienced with home plumbing, we’ve included these instructions to install your Manor Trio System. Please note that by choosing to install your system yourself, you assume the liability for its installation.

Package Contents

System housing (1 head and 3 sumps)
Mounting bracket
1 softener cartridge
2 additional filters depending on your purchase
1 wrench
Tapcon screw pack
System head screw pack
3 O-rings
Lubricant
Installation guide
Warranty/registration card

Due to varying plumbing standards, other bushings and connectors are not included.

System Maintenance

Once installed, your Manor Trio System requires minimal maintenance.
The only maintenance you should expect to perform is replacing the filter and cartridge as needed (about every six months).
You should also replace the O-rings annually. When you replace your cartridge and/or filters, disinfect the sump with bleach and warm water using a sponge or cloth.
Wearing protective gloves clean the inside of the sump with 1/3 cup of bleach and 3 quarts of warm water. Rinse thoroughly.
Again, thank you for choosing NuvoH2O. We look forward to providing you with better-tasting, convenient, eco-friendly, salt-free soft water for many years to come!

Before Installation

Ensure that any electrical plugs in the area are covered or disconnected.
Ensure that the existing plumbing is up to code.
Turn off the water main.
Acquire and install a pressure regulator if you don’t already have one.

Warnings & Cautions

The NuvoH2O softener is intended for the treatment of hard water with alkaline pH; do not install it if inlet water has a pH of 7.2 or less.
Do not use water that is micro-biologically unsafe or of unknown quality without adequately treating or disinfecting water before the system.
Do not allow cartridge contents to come in contact with surfaces comprised of copper, stone (natural or unsealed), carpet, cement, or other flooring.
Head must be installed with the water flowing through the filter side first. If water flows through the softening media, CitraCharge will be filtered out and will not affect your water.
Insulate any outside pipes that can reach extreme temperatures (higher than 80° F (27° C) or lower than 32° F (0° C).
Do not install near electrical appliances.
Maximum working water temperature is 113° F (45° C). The minimum working water temperature is 39° F (4°C). The maximum working water pressure is 100 PSI (6.8 bar). The minimum working water pressure is 7.25 PSI (0.5 bar).
Ensure that the plumbing has been installed according to the plumbing code. Installation must comply with all state and local laws and regulations.
Ensure that the water main has been shut off before installation.
Replace the filter and the cartridge at least every six months or as needed based on water usage. Failure to replace the cartridges in recommended intervals may result in poor softener performance and/or cracks in the housing, causing leakage and possible flooding.
Failure to maintain your system may result in poor performance and/or cracks in the housing, causing leakage and possible flooding.
Lubricate (included) O-rings.
If water leaks between the sump and head, re-lubricate the O-ring or replace the O-ring with a new one.
If the system is unused for an extended time, replace the filter and cartridge before use.
After prolonged periods of non-use (such as during a vacation), it is recommended that the system be flushed thoroughly. Let the water run for five to six minutes before using.
The system sump should be replaced every 7 years to prevent costly repairs or possible water damage
Do not use aerosol sprays (e.g. bug sprays, cleaning fluids, etc) near the system. They contain organic solvents, which may cause cracking or other damage
Avoid dropping, hitting, or scratching sumps. Minor damage from inappropriate handling can lead to cracks and eventual failure

Note: Cannot be added behind an ion exchange system.

Installation Instructions

Verify the water main has been shut off.
Using a stud finder, attach a mounting bracket to the studs in the wall.
Remove the system from the package. Remove the filter and cartridge from the housing. Be sure to check inside the system for loose foam, plastic, or package contents.
With the filter side of the head near the inlet pipe, install the system by attaching the head to the mounting bracket. Ensure that the system is installed vertically with the blue head at the top of the system. Do not invert the system.
If needed install a pressure regulator (E) ahead of the NuvoH2O system. Set for 45-65 PSI. A pressure spike, though unlikely, can still damage the system if it is not protected and potentially result in leaks.
Install a bypass. See the diagram below.
Use 3-4 wraps of Teflon tape to seal the connections.
Use flexible hoses to connect the inlet pipe to the inlet port on the system head and connect the outlet port of the system head to the outlet pipe. Failure to use flexible hoses may result in water leakage.
Lubricate (included) the O-rings at the top of the housing sump.
Remove the protective plastic wrap from the cartridge and filters before inserting them back into the housing.
Insert and seat the cartridge and filter into the sump. Water softening cartridge: the small, round holes on the side of the cartridge must be at the top. See the cartridge replacement instructions for more details.
One at a time, attach sumps (now with the filters and cartridge inside) to the head by rotating counterclockwise. Secure with the wrench provided. NOTE: Depending on your choice of filtration the order placement of your filters will vary:
• Sediment Filter ➡ Iron Filter ➡ Water Softener
• Sediment Filter ➡ Chloramine Filter ➡ Water Softener
• Sediment Filter ➡ Carbon Filter ➡ Water Softener
• Chloramine Filter ➡ Iron Filter ➡ Water Softener
• Carbon Filter ➡ Iron Filter ➡ Water Softener
Loosen the pressure-release valves on the top of the heads using a screwdriver. Do NOT remove the pressure release valves,
only loosen it.
Open the first bypass valve (A), allowing the sumps to fill with water. When water leaks from the pressure-release valves at the top of the heads, tighten to close (B). Do not over tighten.
Close the first bypass valve (A), and allow the cartridge to sit in the housing without water flow for one hour. Open the main valve (C), thus allowing water to flow throughout the household while the filter and cartridge sit idle.
After one hour, close the top bypass valve (C) and slowly open the first and last bypass valves (A & D), allowing water to flow through the system.

NuvoH2O Filter and Cartridge Replacement

Before replacing your filters and cartridge, we recommend having a towel on hand and placing a bucket underneath your softener system to catch any water that may spill. The bucket should also be used to carry your spent cartridge as the concentrated solution can damage flooring if it drips from the cartridge.
Discontinue water flow to the system by closing valves A and D (see diagram on page 3). Open valve C, allowing water to flow to the home. Loosen the pressure release valve in the head of the system with a screwdriver. Use a towel to absorb water
that leaks from the valve.
Using the black plastic wrench provided, turn the sump clockwise (left) to loosen the sump from the head of the system. CAUTION: The sump will be heavy and full of water!
Remove the spent cartridge and place it in a bucket. Turn it upside down into a porcelain sink or tub and let it drain completely. The outside of the cartridge can be rinsed with warm water. The water that empties from the cartridge will be very concentrated. DO NOT allow it to come in contact with copper, stone (natural or unsealed), carpet, cement, or other flooring.
Wash the sump with bleach and warm water using a nonabrasive sponge or cloth. Clean the inside of the sump with 1/3 cup of bleach and 3 quarts of warm water. Rinse thoroughly.
Remove the plastic shrink wrap from your new filter and cartridge and insert them into the sumps. The small, round holes on the side of the cartridge must be at the top.
Inspect the O-ring, on the top of the sump, for wear. Ensure it is seated properly. Lubricate the O-ring with a water-based lubricant or replace it as needed.
Be sure to align the filters and cartridge properly in the sumps and heads. Failure to do so may cause them to crack when tightening the sumps back onto the heads.
One at a time, carefully attach the sumps (now with the cartridge and filters inside) to the head by rotating the sumps counterclockwise. Secure with the wrench provided.
Open the first bypass valve (A), allowing the sump to fill with water. When water leaks from the pressure release valve at the top of the head, tighten to close (B).
Close the first bypass valve (A), and allow the cartridge to sit in the housing with no water flow. After one hour open the main valve (C), thus allowing water to flow throughout the household while the filter and cartridge sit idle.
After one hour, close the top bypass valve (C) and open the first and last bypass valves (A&D), allowing the water to flow through the system.
After installation, allow water to flow through the system without consuming the water, i.e. a shower for at least an hour. This will allow any excess carbon from the filter to exit the system.

Note: If the system is unused for an extended time replace the filter and cartridge before use.

Money-Back Guarantee

We’re so confident in the performance of the Manor Trio System, that if you are not completely satisfied within the first 90 days from the date of purchase, you may return it for a full refund of your purchase price, less shipping and handling. Visit NuvoH2O.com/policies to learn more. Everyone’s water quality is different. If you’re not getting the results you expect, we may be able to help you adjust the treatment level from your softener to improve your water quality. Please contact us if we can be of any assistance. Call 877-688-6426 or email nuvocs@nuvoh2o.com.
Purchases made through third-party resellers and retail partners must be returned through those partners and are subject to their return policies.
5-Year Limited Warranty
In the unlikely event that you experience a manufacturing defect with your system, NuvoH2O may either modify or exchange your softener. To qualify for a warranty, you must purchase the system directly from NuvoH2O or an authorized NuvoH2O reseller, register your system with NuvoH2O, and use only genuine NuvoH2O replacement cartridges and parts. For full warranty details, visit NuvoH2O.com.
Product Registration
To register your NuvoH2O Manor Trio System, visit NuvoH2O.com/register. If you do not have access to a computer please call one of our helpful customer service agents at: 877-688-6426. Or, you can mail the registration card included with your system.