Trail ARMOR TAUBMS-PR800 Polaris Ranger 700 or 800 Under Bed Mud Shield Instructions
- October 27, 2023
- Trail ARMOR
Table of Contents
Trail ARMOR TAUBMS-PR800 Polaris Ranger 700 or 800 Under Bed Mud Shield
Warnings and Product I. ability Disclaimer
This product is intended to be used as a cosmetic accessory under normal
equipment operate on and should not be depended upon or used as a safety
device Manufacturer assumes no liability for personal injury or equipment
damage as the result of the use or installation of this accessory User assumes
all risk User should carefully read all instructions prior to installation
PLEASE NOTE This product was designed, ft, and tested on new vehicle
specifications Any damage, modifications or excessive wear to your vehicle may
require modification to the product and/or your vehicle to ensure proper
fitment
-
For easier access, remove the pin from the hydraulic cylinder bed lift. Tilt the bed back against the tires. Remove factory screws that secure the bedside lip to the bottom of the bed. Retain- you will reuse. Hold one side’s bed panel in place. Secure using removed factory screws along the
outer edge of the panel. Secure black 10 x % into the panel as shown in Picture 1. Secure the remainder of the panel using Trail Amor supplied fasteners in the inner and upper holes. Locations are shown in Picture I above. -
Repeat on another side.
-
Replace the factory pin on the hydraulic cylinder bed lit. Close bed.
Enjoy! Any questions, contact Trail Armor at 662-233-5700 or www.trailarmor.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>