Gonbes GS01 Bluetooth Earphones Smart Sunglasses User Manual
- June 6, 2024
- Gonbes
Table of Contents
Gonbes
User Manual
Power on/off & Bluetooth pairing
- Long press the MFB button for 2 seconds to turn on/off, the blue LED flashes when turning on, and the voice prompt “Power on”
- Power on, enter the pairing mode, and turn on the Bluetooth of the device to be connected, search for GS01 for pairing, and the blue light will flash per 3 seconds after the pairing is successful
- It will automatically enter the pairing mode after disconnecting;
- Automatically connect back to the last connected Bluetooth device after power on, Automatic shutdown without Bluetooth connection in 5 minutes
Audio mode
- One-click the touch area to be volume +, there will be a prompt sound when the volume is adjusted to the maximum
- Long press the touch area for volume –
Call mode
- One-click the MFB button to answer a phone call O One-click the touch area to Reject a phone call
- One-click the MFB button to hang up the current call
Voice assistant
- Double-click the MFB button
Charging mode
- Charging time about 1.5 hours, low battery alarm voice prompt “battery low”
- The low battery alarm interval is 60 seconds, the red light flashes 2 times The red LED is on when charging, and the bl AN? LED is on when it is full.
Specification
- Model GS01
- Distance 10-15m
- Bluetooth Version V5.0+ EDR
- Music Playing time 3-4h
- Bluetooth protocol
- Frequency range HFP/A2DP/AVRCP 2402-2480MHZ
- Phone call time
- Charging Volt 5h USB DC5V
- Charging time 1.5-2h
- Standard by 200h
- Battery
- Weight 3.7V / 120mAh 40g
Smart Sunlassas
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>