IPmitter IPMIT100 Dual Band Wireless Access Point User Guide
- June 6, 2024
- IPmitter
Table of Contents
IPMIT100 – Quick Start Guide
www.systemq.com/PDF
/manual/xIPMIT100.pdf
The IPmitter ceiling and wall access point (IPMIT100) has dual band technology and can simultaneously connect equipment to your LAN on both 5.8GHz and 2.4GHz channels
Powering
Option 1 – Power from 12V DC (via the 2.1mm DC Socket), the current
consumption is 300mA. The IPMIT100 is polarity sensitive so connections must
be made correctly.
Option 2 – Power using 48V PoE, in the RJ45 WAN/POE Socket The
IPMIT100 will take approximately 1 minute to boot up.
- 2.1 mm DC Socket
- WAN PoE
- Reset
- LAN
Indoor Wi-Fi Access Point
For more setup options see the full manual
To setup the IPMIT100, login to the interface on a browser on a Windows PC/ Laptop.
1. Open a web browser, input the IP address of the device. (default = 192.168.1.123)
The IPmitter may be on a different network IP range to the computer, to add another IP range to the Windows PC/ Laptop scan the QR code below for the “how to guide”
www.softcctv.com/helpdesk /kb/faq.php?id=571
2. Input the username and password, and click Login.
Default login details are:-
Default IP 192.168.1.123
Password ipmitter
3. Go to “ Wizard ” on the left, then select the mode required.
AP Mode – Set this mode to allow the IPMIT100 to act as a Wi-Fi access point for devices to connect onto a wired network.
Repeater Mode – Set this mode for a Wi-Fi link of the IPmitter to another existing Wi-Fi network to “extend” and repeat the Wi-Fi signal. The network port then will act as an extension of the original existing network
| LAN Port 1 Speed | 10Mbs/ 100Mbs |
|---|---|
| LAN Port 2 Speed | 10Mbs/ 100Mbs |
| Frequency | 2.4Ghz + 5.8Ghz |
| Wireless Data Speed | 750Mbps |
| Wireless Standard | IEEE802.11AC/N/G |
| PoE Voltage | 48V |
| 12V Input Option | Yes |
| Modes | Access Point/ Repeater |
| Mounting | Wall Or Pole (Not Supplied) |
| Dimensions | 185 x 185 x 30mm |
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise, from errors or omissions in these instructions, or the performance or non- performance of the equipment refered to.
Quick Start Guide – qIPMIT100 Copyright 2021 System Q Ltd
This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated WEE/CG0783SS collection point as defined by your local council.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>