HOMEDEPOT W1WCR4986SS 86.6 Inch Telescoping Stainless Steel Window Curtain Rod Installation Guide
- June 6, 2024
- HOMEDEPOT
Table of Contents
HOMEDEPOT W1WCR4986SS 86.6 Inch Telescoping Stainless Steel Window Curtain
Rod Installation Guide
INSTALLATION
STEP 1.
Place brackets against wall or ceiling at desired locations and mark screw
holes. Use tape measure and level to make sure marked screw holes are
horizontal to each other. Pre-drill two pilot holes for each bracket
(1/4”drill bit) and insert anchors into wall/ceiling and insert screws into
wall anchors.
STEP 2.
If mounting directly into wood or studs, pre-drill two pilot holes for each
bracket (1/4” drill bit) and install bracket on the wall with screws provided.
STEP 3.
Determine projection of brackets. Loosen projection screw, slide bracket to
desired position and tighten projection screw. Repeat for each bracket.
ROD INSTALLATION
STEP 4.
Detach finial from inner rod.
STEP 5.
Assemble rod and shirr drapery treatment onto rod.
STEP 6.
Screw finials onto inner rod. Rotate finial on rod for proper alignment if
required.
STEP 7. Extend rod to desired width and place it into the brackets. Adjust draperies to desired position.
FINAL ADJUSTMENT
STEP 8.
Secure each rod by tightening screws provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>