TOPSTAR TSZ8.5A19-LD00 LED Lamp Instruction Manual
- June 15, 2024
- TOPSTAR
Table of Contents
Self-ballast LED lamp
User Instruction
Product Features
- Compact structure and design – small, light weight, stylish
- Made with high quality parts and materials – high reliability
- Light-emitting elements and parts produced with new manufacturing technology – high lumen output
- The LED bulbs can’t be used in any dimmable circuit .
Product drawing and dimensions
| Model | Input | Power (W) | CCT（K） | Lamp cap |
|---|---|---|---|---|
| TSZ8.5A19-LD00 1-CEC | 120VAC 50/60Hz | 8.5W | 2700-6500K | E26 |
Selection and installation instruction
- Open product packaging and check if product is intact, contact seller if found damaged.
- Check to confirm product rated voltage is same as local power grid voltage.
- Switch off light power.
- Hold bulb by plastic housing and install into light socket.
- Switch on/off as usual when power is connected.
Warning
- Do not put in dripping-wet environment.
- Do not touch bulb when switched on as high surface temperature may scorch and injure skin.
- Lumen output drops when bulb is used beyond rated lumen maintenance period. For better protection of your eyesight, do not use beyond rated period and replace bulb accordingly.
- Use in Damp Locations only
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
ISED Statement
English:This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS (s). Operation is subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any
interference, including interference that may cause undesired operation of the
device.
The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B).
This device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain
Canadian info rmation on RF exposure and compliance.
This equipment complies with Canada radiation exposure limits set forth for an
unc ontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
betw een the radiator & your body.