Richelieu Hardware BTRF24961248 LED Control Receiver Instruction Manual
- June 6, 2024
- Richelieu Hardware
Table of Contents
Richelieu Hardware BTRF24961248 LED Control Receiver
Function introduction
Product Data
- 4 in 1 universal Rf+Bluetooth LED controller, radio frequency· 2.4GHz
- 4 different device modes DIM, CCT, RGBW and RGB+CCT1n 1 controller, and selectable by dial switch
- Enables to control ON /OFF, lighl intensity, color temperature, RGB color of connecled LED lights
- Ultra powerful to control Single Color, CCT, RGBW, RGB+CCT LED strrps
- Controlled through both smart App and remote conlrols, no gateway required
- Easy & quick pairing to the smart App by scanning QR code
- Mesh network, much longer conlrol distance, transmits received signal lo neighbor devices
- Up lo 30m transmIssIon distance belween every two neighbor devices
- Encrypted two->1ay communication, quick status feedback, safe & reliable data transmission
- Compatible with universal RF+Bluelooth remotes, each LED controller can pair to max. 8 remotes
- Waterproof grade· IP20
Safety & Warnings
- DO NOT install with power applied to device.
- DO NOT operate the dial switches for device mode selection with power applied to device
- DO NOT expose the device lo moisture.
Pairwith smartAPP
- Do wIrrng according to connection diagram.
- Please refer to the EasyThings App user manual for details of adding device.
Wiring Diagram
- RGB+CCT Mode
Note: please make sure the dial switches are at position for kGB+CCT mode as shown in above diagram. - RGBW Mode
Note. please make sure the dial switches are al position for GBW mode as shown in above diagram. - CCT Mode
Note: please ma e sure the dial switches are at psition for CCT mode as shown in above diagram. - DIM Mode
Note: please make sure the dial switches are at position for DIM mode as shown in above diagram.
Product Dimension
FCC Caution
This device complies with part 15oftheFCCRules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and(2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes or modifications
not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part15of the FCCRules. These limit
are designed to provide reasonable protection against harmful interference in
are sid entialing installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increasetheseparationbetweentheequipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TVtechnicianforhelp.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>