Rfbeam Microwave K-LD7 24GHz Digital Radar Transceiver Instructions
- June 6, 2024
- Rfbeam Microwave
Table of Contents
Rfbeam Microwave K-LD7 24GHz Digital Radar Transceiver
List of applicable FCC rules
The applicable FCC rules are listed in the section integrators information of
the product datasheet: “This module meets the title 47 of the Code of Federal
Regulations, part 15 section 15.249 for intentional radiators operating in the
24.00 to 24.25 GHz band.“
Summarize the specific operational use conditions
The product has integrated patch antennas. There are no specific operational
use conditions.
Limited module procedures
The product is granted as a single modular transmitter.
Trace antenna designs
The product has integrated patch antennas.
RF exposure considerations
The following is included in the section integrators information of the
product datasheet: “The radiated output power of the device is far below the
FCC radio frequency exposure limits. Nevertheless, the device should be used
in such a manner that the potential for human contact during normal operation
is minimized.”
Antennas
The module has integrated patch antennas.
Label and compliance information
The following is included in the section integrators information of the
product datasheet: “If the label of the module is not visible from the outside
of the end product, it must include the following texts on the label of the
host product:
FCC statement
FCC: Contains FCC ID: 2ASYV-K-LD7
In addition to marking the product with the appropriate IDs, the end product shall bear the following statement in a conspicuous location on the label or alternatively in the user manual: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
Information on test modes and additional testing requirements
The following is included in the section integrators information of the
product datasheet: “Testing for the modular approval has been performed with
the 10m range setting for all available frequency channels which represents
the maximum TX emission configuration with the complete used bandwidth. This
setup can easily be used by the customer for certification purposes.”
Additional testing, Part 15 Subpart B disclaimer
The following warning is included in the section integrators information of
the product datasheet: “The OEM integrator is responsible for the final
compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>