United Creation Technology TCW02 Smart Glasses User Guide

United Creation Technology TCW02 Smart Glasses

Power On & Power Off

1. The eyewear automatically powers up with a built-in body induction sensor that detects skin contact upon wearing.
2. Tap controls are detectable throughout the entire temple. Touch or Slide controls are detectable only in the marked area.

Troubleshoot

If the eyewear does not power on normally, please check the following:

1.  Make sure there is electricity in eyewear;
2.  Check if the eyewear is too loose to detect skin contact. In this case please try manually touch on the contact area of the temple near your ear position.

Phone Call Controls

Tap controls are detectable throughout the entire temple.

Playback Controls

Tap controls are detectanle through the entire temple. Touch or Slide controls are detectable only in Marked Area.

Voice Assistant Controls

Tap controls are detectable throughout the entire temple.

Game Mode Control

Tap controls are detectable throughout the entire temple.

Pairing

The eyewear requires manual pairing with your phone for first-time use.An automatic connection with the same device when powered on is enabled after successful pairing for the first time.

Charging

This eyewear may take 2 hours for a full charge. (IMPORTANT: Please use SV DC charger for charging)

Switch Glasses Frames

Unique magnetic quick-release design allows easy switch between different styles of glasses frames. One pair of TWS audio frame arms can work with multiple kinds of frames.
Align and push in the temple to pair with the glasses frame you choose to wear. Pull out the temple to remove from the glasses frame.

Cautions

This product is non-professional waterproof glasses. Please do not rinse the temples directly. All interfaces need to be kept dry. This product only supports IP67 splash and dust resistance. Protection may be reduced due to daily wear and tear, and is not permanently effective. Do not charge when the interface is wet. Damage caused by liquid intrusion is no longer covered by the warranty.

Warranty

1. Customers are entitled to a replacement or free repair service in case of quality defects and non-human damage found in the product within 30 days upon receipt of the product.
2.  Customers are entitled to free repair service from V.U.H.O for any product proven defective in material or workmanship that results in product failure during normal consumer usage and conditions within the valid warranty period, which is 12 months counting from the date of delivery.
3.  Some states or countries do not allow limitations on how long an implied warranty lasts, so the above warranty term may not apply to you.

Please scan the qr code for more features and information

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2.  this device must accept any interference received, including interference that may cause undesired operation.
   The device has been evaluated to meet general RF exposure requirements.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>