Techwall Electronics BAP-2 Portable Air Purifier Instruction Manual

Techwall Electronics BAP-2 Portable Air Purifier

Instruction

1. Power On/Off button ；Power ON；Long press Power On/off button to switch on the purifier. Indicator⑦light on and the purifier start to work. Power OFF ；Long press Power On/off button can switch off the purifier. The indicator⑦will light off，the unit stop working. Wake up；short press button ① can wake up touch function，and touch function indicator will light on. The function indicator will automatically turn off after 10 seconds of no operation.
2. Fan speed ；Fan speed can be adjusted to 3 levels, high/medium/low ， press button ② can change fan speed. Screen ⑨ can show current fan speed。
3. Automatic Fan speed mode ；press ③ can activate /disable automatic fan speed mode，if this mode is activated fan speed will be changed automatically depending on air quality of current environment.
4. Filter replacement indicator ；need to replace a new filter if this indicator light on. See diagram below, unscrew the bottom cover to replace a new filter.
5. Display of Temperature / Humidity ；press ⑤ to switch between temperature and humidity on screen.
6.   Auto-sweep mode ；press ⑥ to activate or disable this mode。
7. Function indicator ；This indicator light on if the purifier is switched on. And light off if this unit is switched off. Flashing of this indicator mean not enough battery power. Light on red mean the battery is under charging.
8. Power port ；connect the adapter with USB cable to supply power for this unit。

Functions

1. Power On/Off button
2. Fan speed
3. Automatic Fan speedmode
4.  Filter Replacement indicator
5.  Display of Temperature / Humidity
6.  Auto-sweep
7.  Function indicator
8. Power port
9. Screen

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to  Part  15  of  the  FCC  rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,  may cause harmful interference to radio communications.  However,  there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning  the equipment  off  and  on,  the  user  is  encouraged  to  try  to correct  the  interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>