FENIX TK20R V2.0 Rechargeable Dual Rear-Switch Multipurpose Flashlight Instruction Manual

: June 6, 2024
: FENIX

Table of Contents

FENIX TK2OR V2.0 FLASHLIGHT
OPERATING INSTRUCTION
INTELLIGENT OVERHEAT PROTECTION
BATTERY SPECIFICATIONS
BATTERY REPLACEMENT
CHARGING
BATTERY LEVEL INDICATION
LOW-VOLTAGE WARNING
USAGE AND MAINTENANCE
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

TK2OR V2.
RECHARGEABLE
DUAL REAR-SWITCH
MULTIPURPOSE
FLASHLIGHT

| 3000 LUMENS MAXIMUM OUTPUT
---|---
| 475 METERS MAXIMUM BEAM DISTANCE

FENIX TK2OR V2.0 FLASHLIGHT

3000 lumens maximum output; 475 meters maximum beam distance.
One Luminus SFT70 LED with a lifespan of 50,000 hours.
Included a Fenix ARB-L21-5000 V2.0 rechargeable Li-ion battery.
Advanced Pulse-Frequency Transmission System (APF).
Instant activation and strobe with the dual tactical tail switches.
Hidden USB Type-C charging port.
The internal dual-spring structure ensures stable lighting even under severe impact.
Made of durable A6061-T6 aluminum.
Premium type HAIII hard-anodized anti-abrasive finish.
Size: 6.02″ x 1.34″ x 1.00″ / 152 x 34 x 25.4 mm.
Weight: 7.20 oz /204 g (including battery).

OPERATING INSTRUCTION

Switches
The round tail switch is the tactical switch for instant activation. The oval tail switch is the functional switch for output selection and instant strobe.
On/off
Tap the tactical switch to silently and momentarily turn on the light, releasing the light will go out. Fully press the tactical switch to constantly turn on the light, press again the light will go out.
Output Selection
With the light switched on, single-click the functional switch to cycle through Eco—.Low—tMed—High—.Turbo.
Strobe
With the light switched on, press and hold the functional switch for 0.5 seconds to enter strobe, click the functional switch once again to turn back to the general mode.
With the light switched off, press the functional switch to enter strobe, release the light will go out.
Intelligent Memory Circuit
The light memorizes the last selected output excluding the strobe. When turned on again the previously used output of general mode will be recalled.

INTELLIGENT OVERHEAT PROTECTION

The light will accumulate a lot of heat when used on Turbo output levels for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user the reselection of Turbo mode.

TECHNICAL PARAMETERS

Note: According to the ANSVPLATO FL standard. the above specifications are from the results battery under the temperature of 21±3t and humidity of 50% – 80%. The true performance of UV The Turbo output is measured In a total of nine-time including output at reduced levels due to the Mee or protection mechanism n the design.

BATTERY SPECIFICATIONS

Type| Dimensions| Nominal
Voltage| Usability|
---|---|---|---|---
Fenix ARB-L21-5000 V2.0| 21700| 3.6V| Recommended| √√
Fenix ARB-L21-5000U| 21700| 3.6V| Recommended| √√
Fenix ARB-L21-4000P| 21700| 3.6V| Recommended| √√

‘ 21700 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Only using quality batteries with circuit protection will reduce the potential for combustion or explosion: but cell damage or short-circuiting are potential risks the user assumes.

BATTERY REPLACEMENT

Unscrew the light tail and insert the battery with the anode side (+) towards the light head, then screw the light tail back on.

CHARGING

Loosen the light head counterclockwise to reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
The indicator will display red while charging and will turn green when fully charged.
Once charging is completed, be sure to tighten the light head to maintain the dustproof and waterproof ability.

Note:

When charging fails or the battery is reversely connected, the battery indicator will flash red to remind the user to check the battery.
The normal charging time of the included Fenix ARB-L21-5000 V2.0 is approximately 3.5 hours from depletion to full charging.
Recharge a stored light every four months to maintain the optimum performance of the battery.
The light is unavailable while charging.

Note: This only works with Fenix ARB-L21 series 21700 rechargeable Li-ton battery.

BATTERY LEVEL INDICATION

Each time the light is turned on, the indicator (unscrew the light head to see) will indicate the battery level and will last for 3 seconds.
Green light on: saturated 100% – 85% Green light flashes: sufficient 85% – 50% Red light on: poor 50% – 25%
Red light flashes: critical 25% – 1%
Note: This only works with Fenix ARB-L21 series 21700 rechargeable Li- ion battery.

LOW-VOLTAGE WARNING

When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When this happens in Eco output mode, the light blinks 3 times every 5 minutes to remind you to timely recharge or replace the battery.

Note: This only works with Fenix ARB-L21 series 21700 rechargeable Li-ion battery.

USAGE AND MAINTENANCE

Disassembling the sealed head can cause damage to the light and will void the warranty.
Fenix recommends using only a high-quality protected battery.
If the light will not be used for an extended period, remove the battery for proper storage.
Unscrew the tail cap or remove the battery to prevent accidental activation during storage or transportation.
Long-term use can result in 0-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
Periodic cleaning of the battery contacts improves the light’s performance as dirty contacts may cause the light to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: Poor battery level.
Solution: Recharge or replace the battery.
B: The contact or contact point of the battery or flashlight is dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

If the above methods don’t work, please contact your authorized distributor.

INCLUDED

Fenix TIQOR V2.0 flashlight, ARB-L21-5000 V2.0 Li-ion battery, USB Type-C charging cable, Lanyard, Holster, 2 x Spare 0-rings, User manual, Warranty card

WARNING

The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the light directly into anyone’s eyes.
This flashlight will accumulate a lot of heat when used for extended periods, resulting in a high temperature of the flashlight shell. Pay attention to safe use to avoid scalding.
Do not shine an object at close range, to avoid burning the object or causing danger due to high temperature.
The LED of this flashlight is not replaceable; so the entire light should be replaced when the LED reaches the end of its life.
If any of the information provided in this manual is changed, the new version of the manual shall prevail: if your included user manual is an old one, it acquiesces that we won’t send a new manual.

LIGHTING FOR EXTREMES

|
---|---
https://www.facebook.com/fenixproducts/| http://weixin.qq.com/r/EUSfh5zE7MGTrdjk9xED

“Follow” us for more information about Fenix.
FENIXLIGHT LIMITED

Tel: +86-755-29631163/83/93
Fax: +86-755-29631181
E-mail: info@fenixlight.com
Web: www.fenixlight.com

Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku Road, Fenghuanggang Community, Xixiang Street, Baoan District, Shenzhen City, Guangdong Province, China

61.149.221.038-A1-20220107

Documents / Resources

| FENIX TK20R V2.0 Rechargeable Dual Rear-Switch Multipurpose Flashlight [pdf] Instruction Manual
TK20R V2.0, Rechargeable Dual Rear-Switch Multipurpose Flashlight, TK20R V2.0 Rechargeable Dual Rear-Switch Multipurpose Flashlight
---|---