Shenzhen Man Si Da Technology HY-01 Puzzle Music Projection Lamp User Manual
- June 6, 2024
- Shenzhen Man Si Da Technology
Table of Contents
Shenzhen Man Si Da Technology HY-01 Puzzle Music Projection Lamp
OVERVIEW
PRODUCT PARAMETERS
- Name : PUZZLE MUSIC PROJECTION LAMP
- Model : HY-01
- Material ABS+PC
- Size : 115′”11565mm
- Weight About 215g
- Battery capacity : 1200mAh
- Charging time About Sh
- Voltage DCSV/lA
- Power SW
- Working time About5-12h
(Depends on the functional pattern)
User Manual
Before using the product you have purchased, please fully charge the product.
Please read this manual carefully and keep it properly.
Charging
Take out the charging cable and plug it in the power supply, then insert the charging cable to the lamp according to the direction as shown in the diagram below.
Replace The Pattern
Lift up the top retaining ring and place the entire piece of pattern flatly on the projection area then put the fixed ring back in place. If you want to use the jigsaw puzzle, you don’t need to take out the retaining ring and just place the puzzle into it.
Button basic function
- When the projection lamp is off, long press the switch for 5 seconds to turn on the lamp. The light is up and the projection area begin to spin.
- The Bluetooth mode is on automatically when you turn on the lamp and hear the sound. You can connect the Bluetooth named “Bf Speaker” to play music.
- Long press the switch for 5 seconds to turn off the projection lamp.
The light pattern
In the starting state, press the switch every time to switch the light mode
- Warm yellow
- White light
- Pink light
- Random change of light
- Three colors gradient breathing light
- Three colors lights are all on
In the working condition, double-dick the switch to turn on only night light mode, pause the rotation, and reduce the brightness to 50%
Matters Needing Attention
- Before use, please confinn that the current environment and adapters are suitable for using the product and ensure that the product and its components are in good condition.
- Do not disassemble or replace any structure or component of the projection lamp without pennission.
- The projection lamp will generate few heat when working. Please keep the surrounding air convection in order to dissipate heat.
- It is strictly prohibited to work under the condition of high temperature and humidity.
- If the product is flooded, please disconnect the power supply immediately and stop using.
FCC Caution : Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device shall be used with a minimum distance of 20cm from users.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>