T44647 ARH VHC AirHogs Stunt Shot Instruction Manual
- June 6, 2024
- AIRHOGS
Table of Contents
T44647 ARH VHC AirHogs Stunt Shot
- CHARGING PORT
- POWER SWITCH
ASSEMBLY INSTRUCTIONS
For in-depth video instructions go to AIRHOGS.COM/STUNTSHOT
CONTENTS
- 1 x Stunt Shot™
- x Controller / 1 radiocommande / 1 control
- 1 x Sticker Sheet
- 1 x USB Charging Cable
- 1 x Instruction Guide ®
CAUTION:
HAIR ENTANGLEMENT — Tie back and cover hair and secure loose clothing prior
to play.
INSTALLATIONS
HOW TO INSTALL BATTERIES
HOW TO CHARGE 
HOW TO
CONNECT CONTROLLE R
HOW TO DRIVE
HOW TO FRONT WHEELIE
HOW TO FIX DRIFTING
HOW TO INSTALL BATTERIES
Open the battery door with a screwdriver. If used batteries are present,
remove these batteries from the unit by pulling up on one end of each battery.
DO NOT remove or install batteries using sharp or metal tools. 2. Install new
batteries as shown in the polarity diagram (+/-) inside the battery
compartment. 3. Replace battery door securely. Check your local laws and
regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
Turn the vehicle off. 2. Plug the small end of the charging cable into the
charging port. 3. Plug the charging cable into a 5V DC computer outlet. 4.
Charging LED indicates charging. Solid ON for charging and turn OFF when fully
charged. NOTE: LED charging indicator light is inside of the chassis. Look
through the cooling vents to see it.
HOW TO CONNECT CONTROLLER
Turn on the vehicle and place it on a flat surface. 2. Hold the controller
near your truck, press the power button and wait until power light stops
flashing. 3. You are ready to drive. 4. Use the remote control to drive.
CONTROLLER NOT CONNECTING
NOTE: If your truck does not connect to the controller the first time,
turn the truck off, turn the controller off and repeat the HOW TO CONNECT
CONTROLLER instructions.
HOW TO FRONT WHEELIE
Accelerate forwards for 2 seconds. 2. Push the throttle backwards to pop a
front wheelie.
For TROUBLESHOOTING
questions and solutions, please visit our website: AIRHOGS.COM/STUNTSHOT
NOTE: If normal function of the product is disturbed or interrupted,
strong electromagnetic interference may be causing the issue. To reset
product, turn it completely off, then turn it back on. If normal operation
does not resume, move the product to another location and try again. To ensure
normal performance, change the batteries, as low batteries may not allow full
function.
SAFETY PRECAUTIONS:
Keep hands, hair and loose clothing away from the motor/ wheels when power
switch is turned ON. – Remove battery(s) from controller when not in use. –
Parental guidance is recommended for the play. – Keep your toy in your sight
so that you can supervise it all the time. – New alkaline batteries are
recommended for use in controller to obtain maximum performance. – Users
should keep strict accordance with the instruction manual while operating the
product.- Your controller/charger is tailor-made for the LiFeP04 rechargeable
battery used in your vehicle. Do not use it to charge any battery other than
that in the toy. Note: Parental guidance is recommended when installing or
replacing batteries. Under the environment with electrostatic discharge, the
toy may malfunction and require user to reset the toy.
SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.
PRODUCT BATTERY REMOVAL INSTRUCTIONS:
Internal battery is factory installed and non-replaceable. Product disassembly
and battery removal must be performed by an adult. Do not puncture, cut, tear,
compress or deform product during disassembly. Ensure product is turned off,
then use a screw driver to remove screw. Lift end of battery compartment and
slide out battery. Dispose of battery in accordance with your local battery
recycling or disposal laws.
NOTE: Opening of product will render product inoperative and voids
manufacturer warranties. Dispose of remaining product components in accordance
with local laws.
THIS TOY IS EQUIPPED WITH A LITHIUM-ION BATTERY.
SPECIAL LiFe BATTERY INSTRUCTIONS: Never charge battery unattended. – Charge
battery in an isolated area. Keep away from flammable materials. – Do not
expose to direct sunlight. There is a risk of the batteries exploding,
overheating, or igniting. – Do not disassemble, modify, heat, or short circuit
the batteries. Do not place them in fires or leave them in hot places. – Do
not drop or subject to strong impacts. – Do not allow the batteries to get
wet. – Only charge the batteries with the specified Spin Master™ battery
charger. – Only use the batteries in the device specified by Spin Master™. –
Carefully read the instruction guide and use the batteries correctly. – In the
unlikely event of leakage or explosion use sand or a chemical fire
extinguisher for the battery. – Batteries must be recycled or disposed of
properly.
CARE AND MAINTENANCE:
Always remove batteries from the toy when it is not being used for a long
period of time (controller only). Wipe the toy gently with a clean damp cloth.
Keep the toy away from direct heat. Do not submerge the toy in water. This can
damage the electronic assemblies.
BATTERY SAFETY INFORMATION:
Requires 2 x 1.5 V AAA (LR03) batteries. Batteries are small objects.
Replacement of batteries must be done by adults. Follow the polarity (+/-)
diagram in the battery compartment. Promptly remove dead batteries from the
toy. Dispose of used batteries properly. Remove batteries for prolonged
storage. Only batteries of the same or equivalent type as recommended are to
be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in
fire, as batteries may explode or leak. DO NOT mix old and new batteries or
types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable
batteries is not recommended due to possible reduced performance. Rechargeable
batteries are only to be charged under adult supervision. Replaceable-
rechargeable batteries are to be removed from the toy before being charged. DO
NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply
terminals.
CONTAINS
1 X 3.2V 500mAh LiFe BATTERY PACK AND REQUIRES 2 x 1.5V AAA (LR03)
BATTERIES (not Included). Batteries or battery packs must be recycled or
disposed of properly. When this product has reached the end of its useful
life, it should not be disposed of with other household waste. The Waste
Electrical and Electronic Equipment Regulations require it to be separately
collected so that it can be treated using the best available recovery and
recycling techniques. This will minimize the impact on the environment and
human health from soil and water contamination by any hazardous substances,
decrease the resources required to make new products and avoid using up
landfill space. Please do your part by keeping this product out of the
municipal waste stream! The “wheelie bin” symbol means that it should be
collected as “waste electrical and electronic equipment”. You can return an
old product to your retailer when you buy a similar new one. For other
options, please contact your local council.
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
- Reorient or relocate the receiving antenna
- Increase the separation between the toy and the radio or the TV
- Consult the dealer or an experienced TV-radio technician for help
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
Spin Master International B.V. hereby declares that the radio equipment type Stunt Shot™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com
CANADIAN Class B statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Retain this information, addresses and phone numbers for future reference. Before first use: Read the user’s information together with your child. Frequency band(s) : 2.420 – 2.465 GHz / Maximum radio-frequency power transmitted: <10 dBm
Spin Master reserves the right to discontinue the website www.airhogs.com/stuntshot at any time.
- UK – 0800 206 1191, serviceuk@spinmaster.com
- IRELAND – 1800 992 249
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>