SMART LINK PR21838 Medi Minder Guardian User Manual

SMART LINK PR21838 Medi Minder Guardian

Introduction

Your SmartLink Medi Minder Guardian has been designed to provide you with the freedom and peace of mind in that, should you need assistance or HELP, it is available to you 24 hours a day with the simple press of a button.
The modern slimline design of the SmartLink Medi Minder Guardian allows it to be installed unobtrusively anywhere and is ready when you need help. HELP can be summoned by pressing a button on your personal Pendant or Wristwatch, which you can wear both inside your home or outside in the garden, ready for any emergency, giving you the freedom you enjoy for total control at all times.
The SmartLink Medi Minder Guardian has been built to the highest of technical standards for the protection of people and property and manufactured to Australian and International quality standards.
Your SmartLink Medi Minder Guardian can be supplied with additional fixed or portable Radio Key Pendants, which can be worn or placed around the home as needed. Please contact your supplier for more information.

Medi Minder Guardian

Pendants and Detectors

Using Medi Minder Guardian

NORMAL OPERATION

TO CALL FOR HELP

You can make your Medi Minder Guardian Call for Help by either:

Displays and Warnings

Cellular Signal Quality

Cellular UDP/Server

The Medi Minder Guardian has an internal GPRS/GSM Module to perform Network Reporting.
This reporting is used to transmit alarm reporting messages from a subscriber’s site to a Data Monitoring Centre via a mobile data network and the internet.
The alarm reporting messages has packeted into ARMOR IP REPORTING PROTOCOL format, and use the UDP/IP internet protocol to transmit the alarm reporting message to a Data Monitoring Centre by specified Host/Server IP Address and Port Number.

Specifications

Medi Minder Guardian

• Dimensions: L210 x W130 x D35 mm
• Weight: 590gms (including battery)
• Quiescent Current: 1mA
• 9V DC Plug Pack: 9V DC 300mA
• Battery Backup: 4.8V 1600mAh Rechargeable Ni-MH (Part No. 142-031)
• 2-way Radio Receiver: 902-928MHz SRD
• Range: 100 to 300 meters open-air (Subject to environmental conditions)

Transmitter

• Type: Crystal stabilised FHSS
• Frequency: 902-928 MHz (USA & Canada)
• Power Output: < 13dBm

Conforming Standards

• ISO 9001/2000 International Quality manufacturing Standards
• EMC: FCC Part 15B
• WCDMA B2/5， Power＋RSE: FCC Part 22H/24E，
• LTE B2/4/5/12/13 Power＋RSE: FCC Part22H/24E/27L/27H/27F
• Spread Spectrum Low power radio (902~928MHz) FCC Part 15C
• 47 CFR Part 2.1091 MPE
• ICES-003
• RSS-132/133 WCDMA B2/5
• RSS-132/133/139/130 LTE B2/4/5/12/13 RSE＋POWER
• RSS-247 Spread Spectrum Low power radio (902~928MHz)
• RSS-102
• TS 102 230-1/TS 34.123 [SIM Electrical/SVN]
• TS 36.124 RSE [ LTE B2/4/5/12/13]
• CTIA 3.8.2 OTA [LTE B1 B2/4/5/12/13 [WCDMA B2/5]

FCC Regulations:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.

RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.

ISED Notice
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

• EQUIPMENT NAME: Medi-Minder Guardian
• Model: SMIND-GUARD-LTE
• FCC ID: O2K-SMINDLTE
• CANADA IC: 2290B-SMINDLTE
• © Copyright SmartLink
• “A division of NESS CORPORATION PTY LTD” December 2019

SmartLink Medi Minder Guardian User Manual Rev 1.1 For Product: Medi Minder Guardian
Document Part Number: 890-492  © Ness Corporation Pty Ltd ABN 28 069 984 372 Specifications may change without notice.

To the best of our knowledge, the information contained in this manual is correct at the time of print. SmartLink “A division of NESS CORPORATION P/L” reserves the right to make changes to the features and specifications at any time without prior notice in the course of product development.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>