DO Interactive Remote Control Droid 111820 Instructions
- June 5, 2024
- DO
Table of Contents
DO Interactive Remote Control Droid 111820
INSTALLATION INSTRUCTIONS
- Attach antennas to the head of the droid.
- Slide switch to ON position on side of the droid.
- Slide switch to ON position on the back of the remote controller.
- The remote controller will automatically pair with Droid. The pairing LED on the remote controller will start by flashing. Once paired, the LED will turn off signifying a successful connection.
- Remote Controller Functions:
- Recharge droid with micro-usb cable (included).
- Droid LED will flash Red color when charging. Droid LED will change to green color when fully charged.
- Sleep mode after 5 minutes.
Droid will go to sleep if not active on Batuu or at home after 5 minutes. To wake up droid, slide the power switch off and then back on.
REQUIRES (2) (AAA) (1.5V) BATTERIES, INCLUDED.
INCLUDES RECHARGEABLE BATTERY WITH MICRO USB CABLE INCLUDED
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operafion.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, Uses,
and can radiate radio frequency energy and, it not installed and used in
accordance with the instructions may cause harmłul interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. this equipment does cause harmłul
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio / TV technician for help.
Disney hereby declares that this RC car is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>