MEDIATEK BTG200 Linkit Smart 7688 User Guide
- June 5, 2024
- Mediatek
Table of Contents
MEDIATEK BTG200 Linkit Smart 7688
INSTRUCTIONS
- Step 1. Please power on BTG200 with provided power adapter. Once properly powered on, the PWR light will stay on with green light.
- Step 2. Default IP of BTG200 is 192.168.100.1. Please configure your programming device to 192.168.100.10, connect directly to BTG200 and access via the url below. http://192.168.100.1 By default, no password is set, please setup root password according to the Property Installation Worksheet.
- Step 3. Once password is set, please login via the same url http://192.168.100.1
- Step 4. Once logged in, please select the Network Tab for Network Configuration.
- Step 5. Please select Station Mode, then select with WiFi SSID provided in the Property Installation Worksheet.
- Step 6. BTG200 will restarted after SSID and WPA Key is entered. Please allow 3~5 Minutes for restart. The WIFI green LED in the front will blink when property connected to the internet. If WIFI/NET Led is not blinking, please contact support.
- Reset and Login Instructions
FCC warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Notice
This equipment has been tested and found to comply with the limits for a dass
B digital device. pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interierence
in a residential installation. This equipment generates. uses and can radiate
radio frequency energy and, if not installed and used in accordance With the
instructions. may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception. Which can be detennined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to Which the receiver is connected.
- Consult the dealer or an experienced radio / 1V technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause hannful interierence. and
- this device must accept any interference received, including interference that may cause undesired operation.
- This class B digital apparatus complies with canadian ICES-003.
- Cet appareil numerique de la classe B est conforme a la nonne NMB-003 du Canada.
RF exposure warning
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provide with antenna
installation instructions and transmitter operating conditions for satisfying
RF exposure compliance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>