Zhongshan Hongwei Motor Manufacturing 20200708 Power Ceiling Fan Remote Control User Manual
- June 5, 2024
- Zhongshan Hongwei Motor Manufacturing
Table of Contents
DC POWER CEILING FAN REMOTE
CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning
frequency function that has code combinations to prevent potential
interference from other remote units.
Step: 1 Open the remote battery cover and install the DC1.5V*2pcs battery.
Step: 2 Within 30 seconds of turning the receiver’s DC power ON. press the
transmitter “ON/OFF and Timer” button together for about 3 seconds, once the
receiver has detected the frequency, the receiver will make the sound, Bi Bi,
twice. This will indicate the receiver has learned the frequency that was
previously selected on the transmitter.
Note: After the DC power is on, do not press any other button on the transmitter before setting learning. Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, please turn the power off to the receiver. And repeat steps 1 and 2. Remove the battery if not used for long periods of time to prevent damage to the handheld remote.
FUNCTIONS OF TRANSMITTER
- To turn the fan on or turn the fan off. The beginning of the fan will be on the lowest speed (speed 1), when turning the fan on.
- 2. Press this button to increase fan speed and the LED indicator would be in the position”1″
- 3. Press this button to decrease fan speed and the LED indicator would be on the position”2″
- 4. Press this button to decrease fan speed and the LED indicator would be on the position”3″
- 5. Press this button to decrease fan speed and the LED indicator would be on the position”4″
- 6. Press this button to decrease fan speed and the LED indicator would be on the position”5″
- 7. Press this button to decrease fan speed and the LED indicator would be on the position”6″
- : “Timer”, press the button to set the fan timer change. The change model is 1hrs->2hrs->4hrs ->8hrs -> 1hrs ->2hrs->4hrs ->8hrs ->….Press this button one time to change the next timer hours and the LED indicator would be on what you set.
- SW1: Switch to the”S” will be foreward running, if turn to the”W”, the fan will be reversed.
- When pressing a remote button, the first LED indicator would be on. If you press the remote button and the LED indicator would not on, you should change the new DC1.5V*2pcs battery.
- When pressing a remote button, the receiver would make a sound one time for indicating of getting a signal from the remote well.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>