Shenzhen Qi Yuan Science Technology FFRC10A FIFISH Communication Station User Manual
- June 5, 2024
- Shenzhen Qi Yuan Science Technology
Table of Contents
FFRC10A FIFISH Communication Station
User Manual
Model: FFRC10A
The Communication Station FFRC10A is used for the FIFISH series robot of
QINGDAO QIYUAN CXIN KEJI and Shenzhen QIYUAN technology limited company.
It works as a video/image signal repeater station by achieving signal
reception between robot and mobile devices.
Communication Station
| 1. ON/OFF 10. Tether Port | 10. Tether Port |
|---|---|
| 2. Depth Holding (ON/OFF) | 11. Ethernet port |
| 3. LOCK/UNLOCK | 12. LED Brightness (OFF. 1, 2) |
| 4. Left Stick | 13. Photo (As default can be |
| 5. Right Stick customized defined) | 14. Charging Port |
| 6. Right Wheel | 15. Micro SD Slot |
| 7. Left Wheel | 16. Clamp Release Button |
| 8. Video Record/Stop | 17. Clamp for Smart Device |
| 9. Modes (Attitude/Sport/Combine) |
- ON/OFF: Power on/off-key.
- Depth (ON/OFF): Depth information on/off
- Lock/unlock: Lock and unlock the imaging
- Left stick: choose the left side of the video or image.
- Right stick: choose the right side of the video or image
- Right wheel: choose upside of video or image
- Left wheel: choose the downside of the video or image
- Video record/stop: Video record key
- Mode select: change video or image modes.
- Tether port: insert the hole of the communication tether.
- Ethernet port: an Ethernet output port.
- LED brightness: brightness of the LED.
- Photo: press to take a photo.
- Charging port: insert the 5V/3A adapter to charge the battery
- Micro SD slot: can insert a micro SD card to download the data from the internal camera of the robot.
- Button to adjust holder width.
- Holder for mobile phone or pad
Note: The device is restricted to indoor use only when operating in the 5150 to 5250MHz frequency range.
When it works, the router processor will broadcast an SSID: FIFISHRC_xxxx; in the mobile device’s wifi setting, choose to connect to this SSID, then launch FIFISH APP and can see the camera image. The signal transmission path can refer to the block diagram above: Image from the Camera of the Robot go through PLC modem and PHY via Ethernet to arrive at the router processor, processor then forward these data to 5GHz Radio chip via PCI-E, in the end, the Radio chip sends the image and video to a mobile device using a PCB antenna for wireless communication.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Specification
| Function | Operation Frequency | Max RF output power: | Limit |
|---|
Wi-Fi
5.2G(802.11a/n20/n40/ ac20/ac40/ac80)| 802.11a/ n20/ac20:5180MHz~5240MHz
802.11 n40/ac40:5190MHz~5230MHz
802.11ac80:5210MHz| 14.48 dBm| 23dBm.
EU Declaration of Conformity
We,
QINGDAO QIYUAN CXIN KEJI CO., LTD(No. 111 Daoli Street Tianheng Town Jimo
District Qingdao, Shandong, P.R. China) hereby declares that this
Communication Station is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU.
According to Article 10(2) of Directive 2014/53/EU, the FFRC10A can be used in
Europe without restriction.
Warning:
RED
Manufacturer’s Name: QINGDAO QIYUAN CXIN KEJI CO., LTD
Product Name: Sigur MR100-Multi reader
Model number: Communication Station
Operating Temperature: -10℃ to 40℃
This product can be used across all EU member states.
Hereby, QINGDAO QIYUAN CXIN KEJI CO., LTD declares that this Communication
Station product is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. A copy of the Declaration of
Conformity can be found at the Website: http://www.qysea.com
The device complies with RF specifications when the device is used at 20cm
from your body.
Care for the environment! Must not be discarded with household waste!
Restrictions in the 5 GHz band:
According to Article 10 (10) of Directive 2014/53/EU, the packaging shows that
this radio equipment will be subject to some restrictions when placed on the
market in Belgium (BE), Bulgaria (BG), the Czech Republic (CZ), Denmark (DK),
Germany (DE), Estonia (EE), Ireland (IE), Greece (EL), Spain(ES), France (FR),
Croatia (HR), Italy (IT), Cyprus (CY), Latvia (LV), Lithuania(LT), Luxembourg
(LU), Hungary (HU), Malta (MT), Netherlands (NL), Austria(AT), Poland (PL),
Portugal (PT), Romania (RO), Slovenia (SI), Slovakia (SK), Finland (FI),
Sweden (SE), the United Kingdom (UK), Turkey (TR),
Norway(NO), Switzerland (CH), Iceland (IS), and Liechtenstein (LI).
The WLAN function for this device is restricted to indoor use only when
operating in the 5150 to 5250 MHz frequency range.
| ES| LU| RO| CZ| FR| HU| SI
---|---|---|---|---|---|---|---
DK| HR| BE| BG| DE| EE| IE
EL| IT| Cy| LV| LT| SK| MT
NL| AT| PL| PT| FI| SE| UK
TR| NO| CH| IS| LI| |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>