Shenzhen Willboo Digital Technology EM3IN1RV Wireless Charger User Manual
- June 5, 2024
- Shenzhen Willboo Digital Technology
Table of Contents
User Manual
Wireless Fast Charger
Instructions:
Operation:
- The wireless charging emitter region
- USB cable
- Make sure the power adapter 12V 1.5A enough input
-
.Make sure your phone build-in or install a wireless
charging receiver -
Wireless charging is connected after a ticking sound
Specification:
Input: DC 12V/1.5A
Wireless Output: 5W
USB-A Output: 5V/2.4A
USB-C Output: 5V/3A
Standby energy consumption:<10mA
Working frequency rang:100KHZ-200KHZ
Tran safer efficency:72% (max) Launch distance:6mm
Installation diameter:60mm
Tem perature of outer case:55(max)
Size:69x18mm
Weight:50g
Authenticate:CE FCC ROHS
Use:
Phone built-in or add a wireless receiver QI standard transmitter is charged automatically once recognized approximately 5 seconds If you put the offset distance 7mm not charge
Installation:
In-office desk(Dia 60mm) Punch hole w/60mm by Promessional people It can be used on the plane and car
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>