Yoku Energy C1002 Wireless Charger User Manual
- June 5, 2024
- Yoku Energy
Table of Contents
Wireless charge User Manual
C1002
Plugin your charger into a powered USB port, The LEDs should light up white.
Place the Wristband in the slot. The white lights on the charger will turn
orange next to the device when charging properly. the LCD will blink or remain
white if not charging properly or if the device is not placed properly.
Your devices require about 100 minutes to fully charge their lithium-polymer
batteries. Once fully charged, the LEDs on the charger will change back to
white. It is recommended to fully charge your device as you finish the rest of
the setup process. With normal use, your Wristband should last about four days
on a single charge, depending on use.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation between the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– – Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>