Tamco Summit Vehicle Jiangmen T1 Toy Car Music player User Manual
- June 5, 2024
- Tamco Summit Vehicle Jiangmen
Table of Contents
Tamco Summit Vehicle Jiangmen
T1 Toy Car Music player
User Manual
-
USB port: External USB/ automatic identification2.AUX ports: AUX ports can be automatically recognized after input of an external audio source. 3. Power display: the current power is displayed when the music is played or when the music is paused4.One press of this button is to play horn sound/long press control light on/off, 5. Short press to play music/then short press to switch to the previous song/long press to adjust the volume, 6. Story button: Short press story/long press to adjust and reduce the volume7. Mode key: Bluetooth mode/built-in music mode can be switched (U disk /TF card can be inserted to switch The U disk mode F card mode)
-
Normal test
After power on/start, first, check whether all the buttons of the function are normal; press the music speaker button to see if there is a music speaker; press the switch button to see if it will pause/play when the music sounds; and press the music button and the story button long to test the volume increase or decrease.Key test is normal, test USB, memory card, whether can be normal recognition. -
Abnormal test
A. Press the music button immediately to see if the start sound will be cut off. It is normal to cut off.
B. After starting, press all the keys randomly or press several keys at the same time to see if there is a stuck state, then close it and repeat for about three times
C. Pay special attention to confirming whether there are other products being upgraded in the workshop during the test.
If there are, please do not test.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm from the
radiator of your body. This device and its antenna(s) must not be co-located
or operated in conjunction with any other antenna or transmitter.