STILETTO TB3MC 15oz. Ti-Bone 3 Titanium Hammer with Milled Face Instructions
- June 5, 2024
- STILETTO
Table of Contents
**STILETTO TB3MC 15oz. Ti-Bone 3 Titanium Hammer with Milled Face Instructions
**
Replacement Instructions
Secure the hammer and remove face + hardware using a 7/32″ hex extended length socket. Do not use an impact wrench as it will lock up the washers. Remove the contents from package (TB3MR = Milled Face Kit; TB3SR = Smooth Face Kit). Insert face onto head. Ensure that the nail slot is aligned. Insert bolt with washers and tighten by hand. If necessary, use a 16D nail to keep the nail slot aligned while tightening. Once the head is hand tight, secure the hammer and tighten the bolt to 32 foot-pounds using a 7/32″ hex extended length socket.
Maintenance
If your TI-BONE™ 3 face bolt becomes loose, tighten it securely to finish your
job for the day. At the end of that day, remove the bolt and washers
completely and inspect them to make sure there is no damage. If not, re-attach
the washers to the bolt and begin threading into the face until hand tight.
Ensure that the nail slot is aligned. Secure the hammer and use a 7/32″ hex
extended length socket and tighten to 32 foot-pounds of torque. Do not use an
impact wrench.
If a new bolt is needed, use SAE grade 8 carbon steel, thread 3/8″-24 UNF,
length 1.75″, button head with 7/32″ hex drive.
If new washers are needed, use 3/8″ stainless steel wedge lock washers (1
pair).
STILETTO® TOOLS
13135 West Lisbon Road • Brookfield, WI 53005
1-800-987-1849
www.stiletto.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>