QAZQA 103915 LED Wall Lamp Instruction Manual

QAZQA 103915 LED Wall Lamp

INSTRUCTION

ON/OF F Mode

• Press to turn on/off the lamp.
• It remains the last brightness & CCT when turn on the lamp again.

CCT Mode

• The lamp will be in nature light and all bright under initial state. The color temperature is 4000K(±300K).
• Second time to press, it comes with warm light and all bright. The color temperature is 3000K(±300K).
• Third time to press, it comes with cool light and all bright. The color temperature is 6000K(±300K).

Double Dimming Mode

• Slightly pressto adjust brightness in three steps.
• Long press DIM to stepless adjust brightness(10%-100%）.

Wall lamp Installation Guide:

1. Take out the hanging plate, remove the protective film from adhesive stage paste the hanging plate to the wall in ideal position.
2. Take out the hanging plate,fix the plate to wall in ideal position with attached screws. Notice:Hang plate shall be pasted to rigid and smooth wall.uneven wall is not allowed.

Table lamp Installation Guide:

1. Insert the lamp body into the base hole, pay attention to the direction of the positioning card.
2. Take the screws from the base and tighten them with a screwdriver.

SAFETY INSTRUCTION

Please study the instruction manual and below information carefully before installing or using this product. Please keep this user manual for further reference

1.  The luminaires may only be installed by authorized and qualified technicians according the valid regulations for electrical installation.
2.  Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of the terminal connections or voltage control parts.
3.  The electrical supply must be switched off at the outset, preferably by means of a switch in the distribution box, before any installation, maintenance or repair work is undertaken.
4.  Exterior lighting must not be installed during rain.
5.  Take account of the minimal separation distance from other objects and the room required around the fitting.
6.  If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
7.  Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12V low voltage conductors.
8.  When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.
9.  Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components
10.  Take acceunt ef aII availaltle technicaI infermatien.
11.  Take note of the symbols when connecting wires:
12. Neutral L =Live @=Earth
13.  Meaning of symbols:

•  For indoor use only, where direct contact with water is impossible
•  Protection Class I: the little ng must be earthed
•  Protection Class II: the litting is doubled insulated and does not require earthing
• Protection Class 111: the litting is low voltage
• Minimum distance from lighted objects !meters)
•  Only the sell-shielded halogen lamp shou Id be used with the I um i na ire
• Strip the wire to the indicated length jmm);dillerent items require different length
• Connect using the specified cable; different items require different cables
• The type of lamp and maximum size and wattage indicated in each lighting unit must not be exceed; different items require different kind of light sources with different bulb icons
• 220-24ov-soH, The armature is designed to work only with the indicated voltage. Different items requiredifferent working voltage.
• The luminaire can be used in combination with a dimmer
• The reference light angle and light space of the luminaire
• This luminaire cannot be disposed together with normal domestic waste in standard rubbish can, but you have to bring it to a staging area for electrical waste

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>