MIPRO AD-702 Single Channel Antenna Auto Gain Controller User Guide
- June 5, 2024
- MIPRO
Table of Contents
MIPRO AD-702 Single Channel Antenna Auto Gain Controller
Part Names. Fig. 1
- RF Input Connector: Connect to Antenna
- STATE: Calibrate Indicator lit
- CALIBRATE Button
- RF Output Connector
All rights reserved. Do not copy or forward without prior approvals from MIPRO. Specifications and design subject to change without notice. YM 021/07
Application
Application 1. Fig. 2
For pairing with wideband antenna AT-70W / AT-90W I AT-100, if antenna
cable length does not exceed maximum allowance (see reference chart below),
antenna cable can connect directly to “RX Only” connector on the wideband
antenna, then press the CAL. button, AD-702 will detect loss of signal
strength from the cable, and adjust gain level of built-in booster to ensure
system receives the maximum signal strength possible
All rights reserved. Do not copy or forward without prior approvals MIPRO. Specifications and design subject to change without notice. YM 021/07
Application2. Fig. 3:
When antenna cable exceeds the maximum allowance (see reference chart
below), adding a MPB-30 is highly recommended. After pairing up, AD-702 will
simultaneously and automatically detect loss of signal strength from the cable
and adjust gain level of built-in booster in the wideband antenna and MPB-30,
so the system will have its optimal receiving signal.
General Specifications of 500 Coaxial Cable
Note:
Characteristics of the above coaxial cables are industry standard. The signal
loss might vary depending on each brand’s specifications. Hence, for the most
accurate calculation, always refer to the specifications provided by the
manufacturers. All rights reserved. Do not copy or forward without prior
approvals from MIPRO. Specifications and design subject to change without
notice. YM 021/07
Note
Refer to actual product in the event of product description discrepancy.
Disposal
Dispose of any unusable devices or batteries responsibly and in accordance
with any applicable regulations. Disposing of used batteries with domestic
waste is to be avoided! Batteries / NiCad cells often contain heavy metals
such as cadmium(Cd), mercury(Hg) and lead(Pb) which makes them unsuitable for
disposal with domestic waste. You may return spent batteries/ accumulators
free of charge to recycling centers or anywhere else batteries/accumulators
are sold. By doing so, you contribute to the conservation of our environment!
4 All rights reserved. Do not copy or forward without prior approvals from
MIPRO. Specifications and design are subject to change without notice. YM
021/07
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>