Xianyouxianlichengpaibafushishanghang DI-158D-BL 3-In-1 Charging Station User Guide
- June 5, 2024
- Xianyouxianlichengpaibafushishanghang
Table of Contents
Xianyouxianlichengpaibafushishanghang DI-158D-BL 3-In-1 Charging Station
Instruction
- press to make the plug stand up
- push the watch charger up
- press to make the plug stand up
- press and fill up the phone support
- press to secure it
Part list
Note: If parts in the packing box don’t check with the list, please contact us in time.
Paddings for iWatch for below sizes:
- Series 1/2/3 of 38MM
- Series 4/5/6/SE of 40MM
- Series 7 of 41MM
3 in 1 charging station
- Highest internal frequency: 350kHZ
- Input: DC 5V2.1A-5V3A
- Output: DC 5V2A
Warm Tips
- Reach us by your Amazon order detail page (select “order”, “sold by” or “contact seller”) for warranty about it.
- Recommend using 10Wor above adapter (12W adapter is included)
- Do not use any adapter less than 10W, Since it’s not enough to support 3 devices working at the same time.
- Otherwise, it works great for iWatch and AirPods, but not for iPhone. Contact us if adapter not working for 3 devices.
- Do not use the regular apple adapter 5V1A,5W
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>