YED2207A Remote Control Instruction Manual

YED2207A Remote Control

Installing batteries in the Remote Control

1. Open the battery compartment.
2.  Insert batteries, respecting the+ and – polarities.
3.  Replace the cover.

Installing the vehicle battery

1.  Make sure the ON/OFF switch is set to OFF.
2. Open the battery compartment.
3. Insert AA batteries, respecting the + and – polarities.
4. Replace the cover.

INSTRUCTIONS

1. Start the vehicle.
2. To move the vehicle forwards or backwards, push the throttle lever forwards or backwards or press the trigger (depending on the model).
3. To turn the vehicle left or right, press the steering lever to the left or right. Or, depending on the model, turn the steering wheel or move the 2 levers in opposite directions to turn.
4. To stop the vehicle, release the throttle lever.
5. For best performance, always point the antenna towards

DISPOSAL
Waste electrical and electronic equipment (WEEE): When this device reaches the end of its life, please remove all batte­ries and dispose of them separately. Take electrical devices to a col­lection centre for electronic equipment and household appliances. Other components can be disposed of with household waste. The use of the product may be disrupted by electromagne­tic interference. If this is the case, switch the device off and on again following the instructions in the user manual. If the functions are not reset, move to another location.

Instruction sheet and packaging must be retained since it contains important information.

Safety precautions

• Parents: please read the instructions with your children before using the product for the first time.
• Stop the vehicle with the remote control before picking it up.
• Keep hands, hair and clothing away from moving parts when the toy is operating.
• Do not use the vehicle with the radio control in the street. Avoid collisions with people, animals and furniture.
• Warning : any change or modification made to this product that is not expressly approved in the relevant section of the declaration of conformity may terminate the usage authorisation granted to the user.
• he wires are notto be inserted into socket-outlets

Battery warning

• Non-rechargeableatteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries should be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with correct polarity. (+ and-)
• Exhausted batteries are to be removed from the toy.
• The supply terminals are notto be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline batteries, standard batteries (carbon-zinc) and rechargeable batteries (nickel-cadmium).

Care and maintenance

• Always remove the batteries from the toy if it is not used for a long time.
• Wipe the toy gently with a clean cloth.
• Keep the toy away from direct sources of heat.
•  Do not immerse the toy in water, as this could damage electronic components.
• Replace batteries when they become less powerful.
•  Operation temperature S – 35’C
•  Receiver Category 3

Batteries required for the transmitter:
Power supply= CE E3I DC 3V/ 0,5W;2xl,5V”AA”/LR6/AM3 not included

Batteries required for the car:
Power supply= DC 4,SV I 9W; 3 x 1,SV”AA”/ LR6/ AM3 not included

FCC

NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:

• REORIENT OR RELOCATE THE RECEIVING ANTENNA.
• INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
• CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
• CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>