SLAMP La Lollo LED Suspension Lamp L Instruction Manual
- June 5, 2024
- SLAMP
Table of Contents
SLAMP La Lollo LED Suspension Lamp L
Suspension
- Dim: Ø80 x h.35 cm,
- maximum cable
- lenght 140 cm
MADE IN ITALY – INTERNATIONAL PATENT
Utility Model, Ornamental Design, Trade Mark, Copyright on Artist Design
INSTRUCTIONS
After opening the external packaging, lift up the internal package by the tabs, as illustrated in the figure.
Remove the ceiling rose and rigging kit to connect the lamp electronically.
Caution! Make the electrical connection before removing it from the packaging
to avoid damage.
Before assembling the lamp, make sure that the main switch is off.
Make holes in ceiling using the bracket’s precut openings. Insert screw
anchors and fasten the bracket using provided screws, as shown. Do not block
the electrical ceiling wires.
Insert the three provided steel cables through the ceiling rose, as shown. One
of the steel cables must pass through the silicone ring located on the
electrical wire.
VIEW OF THE POWER SUPPLY CONNECTION
For further information, consult power supply guide.
ELECTRICALLY CONNECT THE LAMP
-
Connect the ceiling wires with the INPUT wires through the wire connectors as show in the picture.
-
Connect the OUTPUT wires to the lamp wires through the wire connectors, as show in the picture.
PAY ATTENTION NOT REVERSE THE POLARITY! THE NEGATIVE CABLE IS THE ONE WITH THE BLACK STRIPE -
To make the lamp dimmable, connect the white and blue wires to the dimmer device (not provided) connectors, following the provided LED DRIVER INSTALLATION DRIVE booklet. Do not use a TRIAC DIMMER.
If you don’t want the lamp to be dimmable leave the white and blue wires unconnected as shown in the illustration. -
Fix the ceiling rose to the mounting bracket with the screws.
Lift the lamp from the packaging using the handles.
CONNECT THE LAMP WITH THE STEEL CABLE
Insert the steel cables into the clamps pushing on the upper part. To lengthen or shorten the cables pushing on the upper part as shown.
The length of the steel cable can be adjusted even after having completed the installation. To level the lamp, adjust the steel cable as shown.
ELECTRICALLY CONNECT THE LAMP
Connect the outgoing electrical cable from the ceiling rose to the electrical
connector of the diffuser.
Note: If the lamp’s light source has been damaged, to avoid dangers, it
must be replaced exclusively by the manufacturer, by its customer service, or
by other skilled workers
Our lamp’s surfaces should be cleaned using a soft, water-damp cloth, otherwise use antistatic spray . Under no circumstances should acetone, trichloroethylene, ethyl alcohol, ammonia, or detersive containing even small quantities of these substances be used, because they attack plastic surfaces. Scouring powder, abrasive creams and all cleaning equipment with rough surfaces should also be avoided.
SLAMP is in conformity with Directive 2002/96/EC (Waste Electrical and Electronic Equipment – WEEE).
Directive 2002/96/EC (Waste Electrical and Electronic Equipment – WEEE) The use of the WEEE symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly you will help protect the environment. For more detailed information about the recycling of this product, please contact your local authority, your household waste disposal service provider or the shop where you purchased the product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>