IDEALED ZC05M Smart Zigbee LED Lights User Manual

June 5, 2024
IDEALED

IDEALED ZC05M Smart Zigbee LED Lights

IDEALED-ZC05M-Smart-Zigbee-LED-Lights-PRODUCT

Smart Zig bee LED Lights User Manual
Please read instruction carefully before using the Zigbee LED controller It explain how to use the LED Strip Light with Smart Zigbee controller,which must works with Standac:I Zigbee HUB(required),Compatible with Hue Bridge V2,Smartthings,Tuya Zigbee and Lightify Hub;also work directly with Echo Plus (2nd Gen),Echo

Zigbee Smart Controller

  • Input Voltage:DC 12-24V
  • Connection mode:APP control
  • Connection mode:Common anode
  • Control distance: 10-15 meter

IDEALED-ZC05M-Smart-Zigbee-LED-Lights-1

Wire Connection

How do connect to Zig bee gateway

  1. Download the “Hue” APP on google play or APP store
  2. Connect the lightstrip. controller. adapter and plug in the power.
  3. Searching the light on APP. it could take some time. If does not find the light,power off/on or make a reset.
  4. After successfully finding and connecting the light on the app.you can assign ii to different rooms/areas/groups.

Reset Method 1

Long press the ‘Reset” button more than 3 seconds. The strip lights will blink rapidly 5 times and full bright It clear the network (reset) successfully. The controller wait for the wireless link to zig bee HUB Notice: Searching the lights on the start zig bee Hub Link Gateway,it will take some time.if the gateway doesn·t find this smart light.please try to reset the controller

Reset Method 2

  1. Switch on your device.
  2. Now switch off and on within 2 seconds.
  3. Repeat off/on four times.
  4. Reset is done when the device is switched on in the fifth time and the light stays on after blinking 5 times.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note :This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequence energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation.if this equipmemt does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals