EJAEE T-15 Wireless Microphone System User Manual

EJAEE T-15 Wireless Microphone System

REMINDER

Please do read this manual carefully before using it. Wireless microphones can scatter radio energy, please do follow the instruction to install and operate in case causing harmful influence. Do abide by local radio regulations when using wireless microphones. We can offer you a frequency of 500-960MHz prod- ucts, and please choose a specific range according to with local radio regulations; otherwise, you will take full responsibility of all consequences.

Brief Introduction

In order to provide a better performance experience to players. The system adopts a detachable design concept, it is very easy to install and convenient to use and suitable for variety of occasions. Same time, the colorful TFT display and humanized menu make it easy for operate.

Main Feature

• Support UHF band to avert frequency interference
• Adopt digital chip circuit design, preset multi-channel for selection
• High-efficiency batteries consumption design, battery life reaches 4 hours
• Detachable transmitter design, supports different mic head, such as saxophone mic, lapel mic, head-
• set mic and so on
• Preset 6 kinds of ECHO,12 kinds of EQ,12 kinds of mic sensitivity
• Setting HlLO transmitter power
• Using distance: 60 meters
• It is suitable for performance, live shows, instrument recording, speech and so on.

Receiver & Transmitter Parts

Receiver

RECEIVER SCREEN

• When flashing indicates it is receiving SYNC signal
• Receiver in LOCK status
• Indicates current channel is 10, frequency is 905MHz
• Receiver in MUTE status
• Indicates receiver battery power

Transmitter

TRANSMITTER SCREEN

• When flashing indicates it is sending a SYNC signal
• the transmitter in LOCK status
• 60% volume
• indicates transmitter battery power
• indicates current channel is 10

Echo: Indicates echo mode (0, E1, E2, E3, E4, E5, E6})
EQ: Indicates EQ mode(0dB, L+6dB, L+3dB, L-3dB, L-6dB, M+6dB, M+3dB, M-3dB, M-6dB, H+6dB, H+3dB, H-3dB, H-6dB.)
SEN: Indicates microphone capsule sensitivity(-6dB, -5dB-4dB, -3dB,- 2dB,-1dB, -0dB, 1dB, 2dB, 3dB, 4dB, 5dB, 6dB)
Power: HILO transmitter power for selection

Optional Microphone of Transmitter

Note: after saxophone& headset microphone plug into the transmitter, remember to tighten the nut of the microphone tail.

Receiver & Transmitter SYNC operation

1. Tum on receiver, long press SET button to unlock it then press UP or DOWN button to select channel.
2. Tum on transmitter, long press SET button to unlock then short press it to switch menu.
3. When the target menu flashing, press UP or DOWN button to adjust modelevel. 3Insert receiver 6.35MIM plug into MIX IN’ or ‘AUX IN’ of audio mixer or active speaker.
4. SYNC Operation
   Turn on receiver & transmitter, long press SET button to unlock receiver, then long press SET button again till flashing on the screen. Finally, SYNC receiver & transmitter (as below picture) till both SCreen indicate same channel.

Effect Reset ( ECHO & EQ)

When transmitter in lock status, long press & button at same time to reset 0′ value; Repeat above operation again to restore to original value.

Technique Specification

Comprehensive Performance

• Carrier Frequency
• HF
• Frequency Stabilization:
• t30ppm
• Dynamic Range:

• 90dB

• Total Harmonic Distorion:
• 0.5%
• Frequency Response:
• 40Hz-15KHzt3dB
• Audio Output level:
• Balance 400mV

Receiver

• 90dB
• SN Ratio:

• 80dB

• Image&Spurious Rejection:
• 80dB
• Border Upon Channel Rejection:

• 10OdBu (Sinad=30dB)

• Receiving Sensitvity
• 4 Hours (Lithium Batery)
• Battery Life:
• 5V,>500mA
• Power adapter.

Transmite

• Transmitter Power:
• 10mW
• modulation system
• DOPSK
• Ulitraharmonics
• S40dB than dominant wave
• Battery fe:
• 4 Hours (Lithium Battery)
• Power adapter
• 5V,>500mA

PICKING LIST

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>