Xl Holding Group CR6 Advanced Smart Remote Control User Manual
- June 6, 2024
- Xl Holding Group
Table of Contents
Press the startup button (with the side stand retracted) and the READY lamp
on the instrument board will light.
Operation of Smart Remote Controller
With an advanced smart remote controller, CR6 electric motorcycle can be
locked or unlocked easily by pressing buttons on the remote controller within
30m.
- Button for a physical key. Press to pop out the physical key.
- . Defense button: slightly press to allow the vehicle to enter an anti-theft alarm state.
- Defense cancel button: slightly press to release the vehicle from the anti-theft alarm state.
- Vehicle seeking button: press the button and the vehicle will sound for warning and seeking purpose.
- Startup button: double click; the vehicle can turn on the whole-vehicle power supply without a key.
How to operate the physical lock
- After the power is cut off, turn the handle to the most left, insert the key into the physical lock of the headlock, press down and rotate the key to position 1 to lock the head direction lock; turn the key to the right direction to the power-off position 2 to start the vehicle.
- Insert the key into the handle lock and turn right to power-off position 2; the head direction lock can be turned on. At this moment, the electrical system is off.
- Continue to turn the key right-ward to position 3, the electrical system is on for self-test and the vehicle is standing by. Open and close the storage box
– French: Le present appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisee aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioelectrique
subi, mime si le brouillage est susceptible d’en compromettre le
fonctionnement.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>