JUNIPER geode GNS3 Receiver User Guide
- June 4, 2024
- JUNIPer
Table of Contents
JUNIPER geode GNS3 Receiver
- MCX ANTENNA PORT
- USB TYPE-C PORT
- LED FUNCTION
USB CABLES
USB Type-C to Type-C – Recommended for use as a primary charging cable. Use
when the device is powered ON and charging at the same time. USB 3.0 A to
Type-C – Legacy Cable; for charging when the receiver is powered OFF.
HARDWARE RESET
- This device has a hardware reset function. To operate, press and hold the power button:
- Soft Reset – Press and hold 5 seconds; release when the green LED flashes slowly. This will reset all messages to the default state and clear the almanac.
- Factory Reset – Press and hold 15 seconds; release when the green LED flashes fast. This will reset all messages to the default state, clear the almanac, ephemeris, and real-time clock.
- CHARGE BATTERY
Four to six hours before first use
DOWNLOAD THE GEODE USER MANUAL www.junipersys.com/support/geode/documentation
Geode Connect™ for iPhone®, iPad®, Android™, and Windows PC, and is available
on the App Store®, Google Play, and
www.junipersys.com/support/geode/downloads.
Geode and Geode Connect are trademarks
of Juniper Systems, Inc. iPhone and iPad are trademarks of Apple Inc.,
registered in the U.S. and other countries and regions. App Store is a service
mark of Apple Inc. Android, Google Play, and the Google Play logo are
trademarks of Google LLC. Windows is a trademark of Microsoft Corporation.
Bluetooth is a trademark of Bluetooth SIG, Inc. Use of the Made for Apple
badge means that an accessory has been designed to connect specifically to the
Apple product(s) identified in the badge, and has been certified by the
developer to meet Apple performance standards. Apple is not responsible for
the operation of this device or its compliance with safety and regulatory
standards.
References
- Juniper Systems, Inc. | Rugged Tablets and Handhelds
- Rugged Handheld Computers - Juniper Systems, Inc.