Shenzhen 1mii Technologies RX8616A USB Bluetooth 5.0 Adapter User Manual
- June 5, 2024
- Shenzhen 1mii Technologies
Table of Contents
1mii Technologies RX8616A USB Bluetooth 5.0 Adapter
User Manual
Installation
To avoid software conflict, please uninstall any previously installed third-
party Bluetooth drivers or management software on your computer before
installing the Bluetooth driver software.
The Default Bluetooth drivers provided by Microsoft Windows have limited
functionality, it will be installed automatically after you insert the USB
adapter, you still need to install the full driver software on CD if you want
to access the full functionality (more Bluetooth profiles supported).
System Requirement
- Supported Operating System: Windows 7/8/10 (32/64 bit),
- CPU Speed: 500MHz or higher
- Hard Drive Space: 500 MB
- RAM: 1GB or more
- Installing Drivers from the CD
Connect the Bluetooth adapter to the computer, open the CD in Windows Explorer, and run Setup.exe under the Windows folder
Auto Installation Program
Click Next to start the installation
Click Install if there is a Warning window, check Always trust software from “Realtek Semiconductor Corp”, you need to restart the computer after installation is finished. You will find “Realtek Bluetooth 5.0 Adapter” under Device Manager after the driver software is installed successfully.
Pair Your Devices
The Bluetooth icon should appear in the system tray after the driver is
installed. Right-click the icon and choose”Add a Bluetooth Device” from the
context menu. If you’re using Windows 8 or 10, you’ll see a screen like the
below. Just click the Pair button for the device you want to connect If you’re
using Windows 7, you’ll see a similar screen, select the device you want to
connect and then click Next.
Pairing a Device that Doesn’t Show Up Automatically
If for some reason your device doesn’t appear below, click the “Add Bluetooth
or Other Device” button located at the top of the Settings window.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.